Results 1 to 10 of about 7,541,842 (289)

Digital radiology to improve the quality of care in countries with limited resources: a feasibility study from Angola.

open access: yesPLoS ONE, 2013
ObjectiveSub-standard quality in X-ray image acquisition and interpretation is common in low-resource countries, and can ultimately result in higher patient morbidity and mortality. This study aimed at evaluating; 1) feasibility of implementing a digital
Floriana Zennaro   +9 more
doaj   +1 more source

Ultrastable and flexible glass−ceramic scintillation films with reduced light scattering for efficient X−ray imaging

open access: yesnpj Flexible Electronics
The thickness of the scintillation films in indirect X−ray detectors can significantly influence their luminescence intensity. However, due to the scattering and attenuation of incoherent photons, thick scintillation films tend to reduce light yield ...
Ruizi Li   +9 more
doaj   +1 more source

Understanding Nickel Thin Film crystallization using X-Ray Diffractometry

open access: yesJournal of Applied Sciences and Environmental Management, 2010
Normal, helical and zigzag deposited Ni films were produced by letting a vapour stream of source material impinge on Corning 1737 glass substrates at oblique incidence while rotating the substrate during deposition.
T Otiti, GI Ekosse, TS Sathiaraj
doaj   +1 more source

Growing wetting films: An x-ray study [PDF]

open access: yesPhysical Review B, 1995
The growth kinetics of thin liquid films, completely wetting a solid substrate, are studied. The film thickness is perturbed and reduced by a short thermal pulse. Subsequently the time dependence of the growth process was monitored by x-ray reflectivity measurements in the region of total external reflection.
Strzelczyk, M.   +3 more
openaire   +4 more sources

On the formation of the Ag2Si metastable phase in an Ag-Si film obtained by ion-beam sputtering

open access: yesКонденсированные среды и межфазные границы
Objectives: Nanocomposite films based on Ag-Si compounds have application in many areas of science and technology. However, their manufacturing process can be accompanied by the formation of silicides and metastable phases.
Konstantin A. Barkov   +14 more
doaj   +1 more source

Cotton Cellulose-CdTe Quantum Dots Composite Films with Inhibition of Biofilm-Forming S. aureus

open access: yesFibers, 2019
A cellulose-cadmium (Cd)-tellurium (TE) quantum dots (QDs) composite film was successfully synthesized by incorporating CdTe QDs onto a cellulose matrix derived from waste cotton linters.
Rohan S. Dassanayake   +4 more
doaj   +1 more source

Accuracy of linear-probe ultrasonography in diagnosis of infraorbital rim fractures

open access: yesThe Ultrasound Journal, 2023
Background Maxillofacial fractures are a common cause of visits to emergency department, accounting for more than 400,000 annual visits in the United States.
Chatchai Pruksapong   +2 more
doaj   +1 more source

Pyroelectric composite film for X-ray intensity detection

open access: yesMaterials Research, 2012
Composite material obtained with modified lead titanate (Pz34) ferroelectric ceramic and polyether-ether-ketone (PEEK) polymer matrix was used as sensitive component to measure X-ray intensity in a novel detection system.
Walter Katsumi Sakamoto   +4 more
doaj  

Ag Incorporation in Cu2ZnSnS4 Thin Film Solar Cell Absorbed Layer

open access: yesCailiao gongcheng, 2018
The (Ag1-xCux)2ZnSnS4 (ACZTS) absorption layers with different Ag atomic ratio were fabricated by using co-electrodeposition and magnetron sputtering.
LI Tong   +6 more
doaj   +1 more source

Home - About - Disclaimer - Privacy