Results 41 to 50 of about 9,180,922 (293)

Calibrated X-ray micro-tomography for mineral ore quantification [PDF]

open access: yesMinerals Engineering, 2017
Scanning Electron Microscopy (SEM) based assessments are the most widely used and trusted imaging technique for mineral ore quantification. X-ray micro tomography (XMT) is a more recent addition to the mineralogy toolbox, but with the potential to extend the measurement capabilities into the three dimensional (3D) assessment of properties such as ...
Reyes, F   +5 more
openaire   +7 more sources

Determination of Loss of Reinforcement Due to Corrosion through X-ray Computer Micro-Tomography [PDF]

open access: yesMaterials, 2021
X-ray computer scanning tomography (CT scan) is an increasingly more available technique, which has been applied to material sciences for years. Although most of its use is qualitative for gaining insights on material behavior, quantitative analysis for estimations of deterioration rates is possible.
Fernando França de Mendonça Filho   +3 more
openaire   +4 more sources

X-Ray Tomography

open access: yes, 2013
International audienceThis chapter contains sections titled: Introduction Principle of the first acquisition systems Physical aspects and the direct problem Principle of tomographic image reconstruction Evolution of X‐ray scanners and ...
Peyrin, Françoise, Douek, Philippe
core   +7 more sources

X-ray tomography data of White Etching Cracks (WEC)

open access: yesData in Brief, 2019
This data article contains lab-based micro-computed tomography (μCT) data of cracks and crack networks in 4 different bearings, mainly from wind turbines, which formed the basis for the crack analysis reported in Danielsen et al. (Danielsen et al., 2019).
Søren Fæster, Hilmar K. Danielsen
doaj   +1 more source

X-Ray micro-Computed Tomography and micro X-ray Fluorescence mapping of synthetic emerald by using a laboratory polycapillary optics X-ray tube layout

open access: yes, 2015
This paper relates the X-ray micro-Computed Tomography and micro X-ray Fluorescence 2D mapping of a synthetic emerald performed by a conventional X-ray source matched with polycapillary optics.
POLESE, CLAUDIA   +8 more
core   +2 more sources

A dataset of void characteristics in multidirectional carbon fiber/epoxy composite laminates, obtained using X-ray micro-computed tomography

open access: yesData in Brief, 2019
In the current data article, we present detailed characteristics of voids in carbon/epoxy composite laminates, along with the original image stacks obtained via X-ray micro-Computed Tomography (micro-CT)1.
Mahoor Mehdikhani   +3 more
doaj   +1 more source

Micro- and nanostructure of human teeth : a synchrotron radiation-based X-ray study [PDF]

open access: yes, 2014
The anisotropic composite nature of human teeth guarantees their function for decades under high mechanical loads and adverse chemical conditions. Even more so since only marginal remodelling and repair mechanisms take place in adult teeth.
Deyhle, Hans
core   +1 more source

Fast Projection Matching for X-ray Tomography

open access: yesScientific Reports, 2017
X-ray 3D tomographic techniques are powerful tools for investigating the morphology and internal structures of specimens. A common strategy for obtaining 3D tomography is to capture a series of 2D projections from different X-ray illumination angles of ...
Chun-Chieh Wang   +5 more
doaj   +1 more source

X-ray fluorescence micro-tomography and laminography using an x-ray scanning microscope

open access: yesJournal of Physics: Conference Series, 2009
Using a scanning microscope with a zone plate, x-ray fluorescence micro-tomography was investigated at SPring-8 BL20XU. A 120 nm-thick zinc layer could be resolved in the reconstructed section image. A frozen phytoplankton and a iron impurity of a diamond could be also reconstructed. X-ray fluorescence laminography was tested at SPring-8 BL47XU.
N Watanabe   +5 more
openaire   +1 more source

Applying micro-computed tomography for porosity analysis of polypropylene modified with microspheres [PDF]

open access: yesMATEC Web of Conferences, 2021
Porosity of polypropylene samples was investigated by applying X-ray micro-computed tomography (micro-CT), which is getting more and more popular as a non-destructive method.
Szewczykowski Piotr
doaj   +1 more source

Home - About - Disclaimer - Privacy