Results 201 to 210 of about 15,719 (233)
LSM-YSZ nano-composite cathode with YSZ interlayer for solid oxide fuel cells
Low temperature prepared (La-0.8 Sr-0.2)(0.9) MnO3-delta-Y-0.15 Zr-0.85 O-1.93 (LSM-YSZ) nano-composite cathode has high three-phase boundary (TPB) density and shows higher oxygen reduction reaction (ORR) activity than traditional LSM-YSZ cathode at ...
Baofeng Tu, Mojie Cheng, Daan Cui
exaly +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
2014
The influence of reduction-oxidation treatment (redox-cycling) at 600 ???? on the structure, strength and electrical conductivity of 8YSZ???50NiO ceramics as solid oxide fuel cell anode substrate was studied to determine its treatment regimes.
openaire +4 more sources
The influence of reduction-oxidation treatment (redox-cycling) at 600 ???? on the structure, strength and electrical conductivity of 8YSZ???50NiO ceramics as solid oxide fuel cell anode substrate was studied to determine its treatment regimes.
openaire +4 more sources
Effects of Polarization on the Microstructural Changes at the YSZ/Ni-YSZ Interface
ECS Transactions, 2019This study examines the effect of Ni migration near the interface with the electrolyte after fuel cell (SOFC) and electrolysis mode (SOEC) operation on nickel-yttria stabilized zirconia (Ni-YSZ) electrodes. The experimental dataset consists in a series of short-stacks tested under different polarization conditions and durations.
Rinaldi, Giorgio +4 more
openaire +1 more source
New insights on the role of YSZ in a NiAl2O4/Al2O3–YSZ catalyst
Applied Catalysis A: General, 2015Abstract Yttria stabilized zirconia (YSZ) role as co-support in alumina (Al2O3) supported Al–Ni spinel (NiAl2O4) was investigated from three perspectives: (a) influence on catalyst morphology, (b) influence on catalyst crystalline phases, and (c) role during diesel steam reforming tests.
Ines Esma Achouri +3 more
openaire +1 more source
Fabrication and Characteristics of YSZ–YSZ/Al2O3 Double-Layer TBC
Oxidation of Metals, 2011A novel YSZ–YSZ/Al2O3 (YSZ means 6 wt% yttria partially stabilized zirconia) double-layer thermal barrier coating was fabricated using composite sol–gel and pressure filtration microwave sintering (PFMS) technologies. In this double-layer coating, the top layer was YSZ ceramics with a thickness of about 150 μm and the bottom layer was composed of micro-
C. Ren, Y. D. He, D. R. Wang
openaire +1 more source
Deposition of YSZ/Si and YBCO/YSZ/Si layers by MOCVD
Physica C: Superconductivity, 1994Abstract This paper deals with the preparation of high quality c-axis orientation of YBCO thin films on Si(001) coated with YSZ (yttria stabilized zirconia) by MOCVD.
G. Garcia +4 more
openaire +1 more source
Thermophysical Properties of YSZ and Ni-YSZ as a Function of Temperature and Porosity
2008The thermal diffusivity, heat capacity, thermal conductivity, coefficient of thermal expansion adn elastic properties of Ni-YSZ and YSZ are reported in the temperature interval between 20C and 1000C. Specific heat capacity (Cp)and thermal diffusivity (a) were determined by differential scanning calorimetry (DSC) and by the laser flash method ...
M. Radovic +4 more
openaire +1 more source
Degradation of SPS-Fabricated YSZ and Nd2O3-YSZ Ceramics in Supercritical Water
Journal of Materials Engineering and Performance, 2016Zirconia (ZrO2) ceramics are being considered as a candidate material for thermal insulating barriers in pressure tubes used in the supercritical water (SCW) nuclear reactors. However, the literature suggests that zirconia may undergo a detrimental phase transformation which is accelerated in aqueous environments.
A. Siebert-Timmer, L. Bichler
openaire +1 more source
Agglomeration behavior of nickel particles on YSZ and TiO2-doped YSZ electrolytes
Journal of Power Sources, 2012Abstract Agglomeration behavior of nickel thin films on the yttria stabilized zirconia (YSZ) and TiO 2 doped-YSZ electrolytes under a reducing condition and at solid oxide fuel cell (SOFC) operating temperatures was investigated by scanning electron microscopy (SEM) and scanning probe microscopy (SPM) to clarify whether this method is appropriate to
Haruo Kishimoto +7 more
openaire +1 more source

