Results 111 to 120 of about 1,345,661 (295)
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
MATEC Web of Conferences, 2017 The mutual induction between the phase wires of the different overhead lines which situate close to each other cause unbalanced redistribution of currents in the line wires. This leads to emergence of the outof-balance zero sequence current which affects
Ukraintsev Alexandr V., Nagay Ivan V.
doaj +1 more source
Advanced Engineering Materials, EarlyView.Carbon nanomaterial‐reinforced epoxy composites exhibit pronounced piezoresistive behavior, enabling intrinsic damage sensing under cyclic and fatigue loading. This review critically compares carbon nanotube and graphene systems, correlating filler content, percolation threshold, and gauge factor with sensing stability and damage evolution.
J. M. Parente +3 more
wiley +1 more source
3D‐Printed Giant Magnetoresistive (GMR) Sensors Based on Self Compliant Springs
Advanced Engineering Materials, EarlyView.This work explores 3D‐printed GMR sensors utilizing self‐compliant spring structures and conductive PLA composites. By optimizing arm width, we achieved high piezoresistive (0.34%/mm) and magnetoresistive (0.77%/mT) sensitivities. Demonstrated through Bluetooth‐integrated pressure and magnetic position sensing, these full printed low‐cost, customizable
Josu Fernández Maestu +4 more
wiley +1 more source
Kongzhi Yu Xinxi Jishu, 2013 This paper illustrated var and negative sequence comprehensive compensation principles of cascaded static var generator(SVG) with star-configuration. The mathematical expression of zero-sequence voltage was deduced, and subsequently zero-sequence voltage
XIONG Qiaopo, LUO An, ZENG Zhizhen
doaj
Zhejiang dianliDue to the inherent output fluctuations of inverter-interfaced distributed generators （IIDGs）， the fault characteristics of distribution networks have changed， posing challenges for relay protection setting.
LI Juan +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study investigates how tramp elements from increased scrap usage influence phase transformations in low‐alloyed steel. Combining dilatometry and microscopy reveal that tramp elements delay transformations, reduce critical cooling rates and increase hardenability.
Lukas Hatzenbichler +5 more
wiley +1 more source
International Journal of Electrical Power & Energy SystemsAfter the single-phase high impedance fault (HIF) occurs in distribution networks, it is difficult to select the faulted feeder and locate the fault section due to the weak fault current and susceptibility to noise interference.
Ao Li +4 more
doaj +1 more source
Detection of Zero-Sequence Current and its Current Sensor.
IEEJ Transactions on Industry Applications, 1993 Toshikatsu Sonoda +2 more
openaire +2 more sources