Results 41 to 50 of about 60,948 (246)
Advanced Engineering Materials, EarlyView.New features on yttria‐stabilized zirconia after exposure at 1500°C: Newly discovered pyramidal structures on an old material. After exposure at 1550°C on the cross section of YSZ new features, namely pyramidal structures are discovered. These structures grow with time, increase in numbers, appear as singularities, are often arranged in strings, and ...
Doris Sebold +2 more
wiley +1 more source
Journal of Magnesium and Alloys, 2014 Previous studies have proved that the zirconium (Zr) alloying and grain refining performance of a Mg–Zr master alloy on Mg alloy is closely related to the distribution of Zr particle size, and a Mg–Zr master alloy with more Zr particles in size range of ...
Chengqi Wang +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Mg–Zn composites with a thickness of 0.21 mm were fabricated using roll bonding of a kirigami‐patterned Mg alloy inlay within a Zn matrix. Thermal activation following this process led to the formation of tailored intermetallic structures, which provided the composite with enhanced flexural strength.
Yaroslav Frolov +4 more
wiley +1 more source
Lattice Stability and Elastic Properties of Zr-Ti-X Alloys (X = Al, V) by the First Principles Study
Metals, 2020 Based on a certain ratio of Zr and Ti atomic fractions according to Zr47Ti45Al5V3 (wt.%), the lattice constants, lattice stability, and elastic properties of Zr-Ti-X alloys (X = Al, V) in body-centered cubic (BCC) (β phase) and hexagonal close-packed ...
Wenxiong Duan +4 more
doaj +1 more source
Time‐Dependent Oxidation and Scale Evolution of a Wrought Co/Ni‐Based Superalloy
Advanced Engineering Materials, EarlyView.This study shows how a new wrought Co/Ni‐based superalloy resists oxidation at 800 ∘$^\circ$C. The oxide scale changes from rough, fast‐growing spinel to a dense, protective chromia–alumina layer. Atom probe analysis reveals tiny refractory‐rich bubbles at the interface that mark the transition to long‐term, diffusion‐controlled protection ...
Cameron Crabb +6 more
wiley +1 more source
Yankuang ceshi, 2013 Zirconium titanium placer is an ore which is extremely difficult to be digested. It is almost insoluble in all kind of acid except HF. Moreover, Hf, Ti and Zr in the ore tends to hydrolyze to form insoluble partial hafnium acid, metatitanic acid and ...
ZHAO Qing-ling, LI Qing-cai
doaj
Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys
Advanced Engineering Materials, EarlyView.Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak +3 more
wiley +1 more source
Materials Research ExpressDue to it has large saturation magnetization (Ms), high magnetocrystalline anisotropy field and high ferromagnetic resonance (FMR) frequency, barium ferrite (BaM) has attracted more and more attentions in the fields of magnetic recording media, permanent
Wenfei Xie +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Reproduction of stacking fault energy calculations from literature with a semi‐automated large language model‐assisted extraction procedure: extraction of simulation protocol, atomistic structures, computational parameters, and reported results, ontology alignment, knowledge graph construction and, finally, recomputation forvalidation.
Sepideh Baghaee Ravari +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study shows that superalloys used in aircraft engine disks become much more prone to deformation at high temperatures if they have been strained during manufacturing. This effect increases with the level of prior strain but eventually reaches a limit.
Fabio Machado Alves da Fonseca +9 more
wiley +1 more source