Results 1 to 10 of about 586 (166)
Simulation Analysis of Grounding Characteristics of Cable Based on ATP-EMTP
In order to improve the operational safety and stability of power cables, it is necessary to conduct targeted research on different grounding modes. Firstly, the appropriate cable parameters were selected according to the specific use, and the model was ...
Youcong Huang +6 more
doaj +3 more sources
This paper discusses the step and touch voltages, based on body resistance, in a grounding grid after a lightning strike at a 434-/21-kV substation. To ensure grounding grid safety, the maximum step and touch voltage should not exceed the safety criteria
Sang-Bong Rhee +2 more
exaly +3 more sources
Using alternative transient program and electromagnetic transients programs (ATP/EMTP) in lightning overvoltages analysis [PDF]
The goal of this paper is to introduce a procedure for risk assessment of insulation failure due to storm surges. The simulations were carried out in ATP / EMTP software, which allowed the use of the Monte Carlo method for the statistical analysis of ...
Mrvić Jovan +4 more
doaj +1 more source
Application of the Heidler function in electromagnetic transients programs [PDF]
The paper analyzes the possibility of using the Heidler function in programs for electromagnetic transients. The parameters of the Heidler function are calculated for various standard waveforms, where greater accuracy is shown for certain waves than with
Mrvić Jovan +2 more
doaj +1 more source
Optimization of dynamic MOSA model parameters using ATP/EMTP software tool [PDF]
This paper demonstrates the procedure for estimating parameters of a dynamic metal-oxide surge arrester model by using a genetic algorithm, implemented in ATP/EMTP graphic preprocessor (ATPDraw) optimization module.
Jasika Ranko +3 more
doaj +1 more source
Simulation of electromagnetic influence of railway overhead contact system on disconnected transmission lines by the ATP-EMTP programme [PDF]
This paper is devoted to experimental and calculating research of induced voltage on disconnected transmission lines caused by the influence of AC railway overhead contact system.
Zalesova O. V.
doaj +1 more source
Research on VFTO Identification of GIS Based on Wavelet Transform and Singular Value Decomposition
The accurate identification of Very Fast Transient Overvoltage (VFTO) is the key of overvoltage control in modern smart grids. In order to accurately identify VFTO generated by the operation of a disconnector in Gas Insulated Substation (GIS), a VFTO ...
Gang Xiao +7 more
doaj +1 more source
Use of the EMTP-ATP Software to Develop a Dynamic Model of the Technological Centre
This paper deals with analysis of power generating units installed within the technological centre. To be able to analyse behaviour of such a complex system with accumulation, the dynamic model of the technology was created using the EMTP-ATP software ...
Tomas Mozdren +3 more
doaj +1 more source
[Introduction] The safe and stable operation of UHV transmission lines is essential to the safety of power grids. When the new substation deconstructs the original long line in the power grid planning and construction, the following problems, such as the
ZHENG Xing, CHEN Yipeng, QI Donghui
doaj +1 more source
This paper proposes three techniques for locating lightning strikes in a 115 kV transmission system over 88.5 km, based on the arrival time of a transient wave obtained from a discrete wavelet transform (DWT).
Pathomthat Chiradeja +1 more
doaj +1 more source

