Results 91 to 100 of about 1,235 (211)

Microstructure and Dry/Wet Tribological Behaviors of 1% Cu-Alloyed Austempered Ductile Iron. [PDF]

Materials (Basel), 2023
Hsu CH, Lin CY, You WS.
europepmc   +1 more source

The influence of copper content on corrosion behavior of ductile iron and austempered ductile iron

, 2018
oai:repozitorij.simet.unizg.hr:simet_232The effect of copper content on corrosion behavior of ductile iron and austempered ductile iron was investigated in 0.5 mol dm-3 NaCl solution at T = 20°C by open circuit potential measurements, linear and ...
Čatipović, Nikša, Živković, Dražen, Dadić, Zvonimir, Batinović, Josip, Vrsalović, Ladislav, Kožuh, Stjepan, Gojić, Mirko   +6 more
core  

Abrasive Wear of Mining Chain Drums Made of Austempered Ductile Iron in Different Operating Modes. [PDF]

Materials (Basel), 2022
Wieczorek AN, Wójcicki M, Drwięga A, Tuszyński W, Nuckowski PM, Nędza J.   +5 more
europepmc   +1 more source

Fractographic analysis of austempered ductile iron

Fatigue & Fracture of Engineering Materials & Structures, 2015
AbstractThis investigation involves a systematic study of the fracture surfaces of two grades of austempered ductile iron (ADI) broken under quasi‐static, dynamic and cyclic loading conditions. The study used electron microscopy, optical microscopy and image post‐processing.
Fernandino, Diego Omar, Boeri, Roberto Enrique   +1 more
openaire   +2 more sources

Properties and Structure of High-Silicone Austempered Ductile Iron

Archives of Foundry Engineering, 2014
The results presented in this paper are a continuation of the previously published studies. The results of hest treatment of ductile iron with content 3,66%Si and 3,80% Si were produced.
Krzyńska A., Kochański A.
doaj   +1 more source

The Effect of Heat Treatment Parameters on Microstructure and Toughness of Austempered Ductile Iron (ADI)

, 2011
In this investigation, the effect of heat treatment parameters on the microstructure and impact energy as a measure of toughness of the austempered ductile cast iron (ADI) was studied. Yblocks were casted from ductile cast iron with following composition:
S.P.H. Marashi, S.M.H. Mirbagheri, K. Sohrabi, Amir Abedi, M. Marvastian   +4 more
core   +1 more source

Physio-Mechanical Investigation of Austempered Ductile Iron

, 2018
The results of experimental (physical and mechanical) study of Austempered Ductile Iron (ADI) are presented. The aim of the investigation is to locally produce ADI and to have a closer look into the mechanical properties of this very attractive cast ...
E. O, Ajoge,, T. I, Levi,, D. K, Dangtim,, M. E, Ibrahim,   +3 more
core  

Structural and Phase Analysis of the Ausferritic Ductile Cast Iron Matrix Obtained by Heat Treatment and in the Raw State

C
This paper presents a comparative analysis of ausferritic ductile cast iron matrix obtained through heat treatment and in its raw state. Ausferrite without heat treatment was achieved by modifying the chemical composition, while nodular graphite was ...
Leszek Klimek, Grzegorz Gumienny, Bartłomiej Januszewicz, Radomir Atraszkiewicz, Katarzyna Buczkowska   +4 more
doaj   +1 more source

Characterisation of machinability of Austempered Ductile Iron through drilling

, 2008
Characterisation of machinability of Austempered Ductile Iron through ...
Guy Littlefair (13071435), Ashwin Polishetty (13058856), S Singamneni (13640131)   +2 more
core  

Effect of Phenomena Accompanying Wear in Dry Corundum Abrasive on the Properties and Microstructure of Austempered Ductile Iron with Different Chemical Composition

Archives of Metallurgy and Materials, 2015
The research described in this article is a fragment in the series of published works trying to determine the applicability of new materials for parts of the mining machinery.
Myszka D., Wieczorek A.
doaj   +1 more source