Results 51 to 60 of about 9,919 (312)
Large multistage axial turbines
Energy Procedia, 2017 Abstract 1. Though multistage axial turbines are being widely used since many decades for water steam expansion or in gas turbines, their use in ORCs has traditionally found limitations as a consequence of the choice of designing turbines with cantilever arrangements. 2. The choice of the cantilever arrangement is mainly related to the advantages of
Roberto Bini, Davide Colombo
openaire +1 more source
Advanced Engineering Materials, EarlyView.A two‐dimensional multiscale finite element analysis framework was established for the first‐generation MoSiBTiC alloy, and the mechanical and fracture‐related parameters of the constituent phases were calibrated through experiments and simulations. The framework provides a basis for analyzing crack propagation behavior in its complex microstructure ...
Junfeng Du +4 more
wiley +1 more source
Turbine cooling and heat transfer modelling for gas turbine performance simulation [PDF]
, 2015 The successful design of cooling systems for gas turbine engines is a key factor to feasibility of new projects, as the trend for increasing turbine entry temperatures implies requirements for more sophisticated cooling methods.
Apostolidis, Asteris
core
Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys
Advanced Engineering Materials, EarlyView.Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak +3 more
wiley +1 more source
Rotor integrity design for a high-speed modular air-cored axial-flux permanent-magnet generator [PDF]
, 2011 The rotor integrity design for a high-speed modular air-cored axial-flux permanent-magnet (AFPM) generator is presented. The main focus is on the mechanical parametric optimization of the rotor, which becomes a more dominating design issue over ...
Luk, Patrick Chi-Kwong +5 more
core +1 more source
Effect of the Diameter of Pressure-Balance Pipe on Axial Hydraulic Thrust
Journal of Marine Science and Engineering, 2021 The axial hydraulic thrust has great influence on the safety and stability of a pump turbine. A common way to balance hydraulic thrust is to install a pressure-balance pipe, and the change in pipe diameter is one of the important factors affecting axial ...
Fei Zhang +3 more
doaj +1 more source
Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites
Advanced Engineering Materials, EarlyView.Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter +9 more
wiley +1 more source
Current Status and Challenges in Data Collection for Aerospace Coatings Deposited by Plasma Spraying
Advanced Engineering Materials, EarlyView.An innovative approach has been integrated into the GRENAT project to optimize plasma spraying and coating performance. Raw materials are accelerated and melted in the plasma generated by torches, creating coatings. Monitoring sensors collect process data which are combined with ex situ characterization data.
Lila Randriamananjara +8 more
wiley +1 more source
Comparison of several Direct-Drive PM Generators for Tidal Turbines [PDF]
, 2013 L’article présente la comparaison des dimensionnements de génératrices à entraînement direct pour des cahiers des charges d’hydroliennes. Deux types de structures magnétiques (à flux radial et à flux axial) sont étudiés.
CHARPENTIER, Jean-Frederic +3 more
core
Radial Mixing in an Axial Turbine [PDF]
Volume 1: Turbomachinery, 1994 The objective of this work was to examine radial mixing in an axial turbine from a number of different perspectives. These include: (1) its impact on the spanwise distributions of the force on the airfoils and the change in the fluid momentum as it passed between them, (2) the mixing coefficient distribution based on measured secondary flow velocities,
openaire +1 more source