Results 161 to 170 of about 2,232,295 (199)

Dynamic Control of the Brushless Doubly Fed Induction Generator Under Unbalanced Operation

IEEE Transactions on Industrial Electronics, 2013
The brushless doubly fed induction generator (DFIG) (BDFIG) shows commercial promise for wind power generation because of its lower maintenance needs compared to the widely used DFIG. From power grid codes, installed wind turbines are sometimes required to be capable of operating under unbalanced grid conditions.
Shiyi Shao, Teng Long, Ehsan Abdi-Jalebi, Richard A. McMahon   +3 more
openaire   +1 more source

Operational principles of brushless servomotors

1990
Abstract A brushless servomotor has been developed by using interdisciplinary mechatronics engineering. A mechanical switching device (commutator) is replaced by electronic circuits and controllers, resulting in a maintenance-free and high-performance servo drive. This chapter also describes various other kinds of technologies used in
openaire   +1 more source

Analysis of brushless exciter operation in all modes of rotating rectifier

2009 4th IEEE Conference on Industrial Electronics and Applications, 2009
In this paper the operation of brushless exciter is investigated and a suitable model for use in time-domain simulation of power systems is derived. An efficient voltage-behind-reactance synchronous machine model is used for the exciter. The theoretical equations, describing the operation of rotating rectifier in three rectification modes are derived ...
M. Shahnazari, A. Vahedi
openaire   +1 more source

Analysis and Design of a PM Brushless Motor for High-Speed Operations

IEEE Transactions on Energy Conversion, 2005
This paper deals with the design of a 1-kW permanent-magnet (PM) brushless motor operating in the speed range of 20-40 k r/min. The design procedure involves a parametrical investigation of the most adequate motor configuration by means of a coupled thermal and electromagnetic analysis.
BIANCHI, NICOLA, BOLOGNANI, SILVERIO, LUISE, FABIO   +2 more
openaire   +2 more sources

Fault-tolerant operation of brushless machines having magnets in the stator

2009 IEEE International Electric Machines and Drives Conference, 2009
The doubly salient permanent magnet (DSPM) machine is a new class of brushless machine having magnets in the stator. In this paper, a strategy for fault-tolerant operation of a DSPM motor drive is proposed. In order to enhance the faulty electromagnetic performance, the DSPM motor operates in a remedial brushless AC (BLAC) mode under the open-circuit ...
Wenxiang Zhao, Ming Cheng, Wei Hua, Xiaoyong Zhu, Yunqian Zhang   +4 more
openaire   +1 more source

Optimal operation of the rotating transformer brushless excitation of synchronous machine

2003 IEEE International Symposium on Industrial Electronics ( Cat. No.03TH8692), 2004
The brushless excitation of synchronous machines is an attractive solution for wound rotor machines, since no slip rings are necessary. The paper investigates the rotating transformer method, where the excitation machine is a wound rotor induction machine supplied by an excitation converter.
K. Veszpremi, I. Schmidt, M. Hunyar
openaire   +1 more source

Operating modes of the brushless DC motor with a 120 degrees inverter

IEEE Transactions on Energy Conversion, 1990
An analysis of the brushless DC motor with a 120 degrees inverter is presented. It is shown that the brushless DC motor-120 degrees inverter system has several distinct operating modes. The status of the motor phase current in which the inverter transistors are not conducting (gated off) is used to classify the modes of operation.
S.D. Sudhoff, P.C. Krause
openaire   +1 more source

Operating Condition Generalization Network for Fault Diagnosis of Brushless DC Motors

IEEE Transactions on Industrial Electronics
International audience ; Existing fault diagnosis methods for brushless dc motors (BLDCMs) encounter problems of limited adaptability in terms ofmultiple faults, multiple motor types, and cross-operating conditions. Therefore, we propose an operating condition generalization network (OCGN) based on the recently proposed domain-invariant feature ...
Chong Luo, Jianyu Wang 0015, Enrico Zio, Qiang Miao   +3 more
openaire   +2 more sources

Modeling and operation analysis of the cascade brushless doubly-fed machine

ICEMS'2001. Proceedings of the Fifth International Conference on Electrical Machines and Systems (IEEE Cat. No.01EX501), 2002
The brushless doubly-fed machine is the most effective type of electrical machine suitable for driving windmills or water pumps to perform speed-adjusting, energy-saving operation, which make give it very good application prospects. In this paper, the practical mathematical model for a cascade brushless doubly-fed machine was derived in detail and the ...
null Bian Songjiang, null He Yikang, null Zhang Hui   +2 more
openaire   +1 more source

Modeling of polyphase brushless exciter behavior for failing diode operation

IEEE Transactions on Energy Conversion, 1998
This paper describes an original numerical method for modeling rectified polyphase salient pole synchronous machines which are commonly utilized for large turbo-generator brushless excitation systems. Simulating this kind of system under normal (and especially abnormal) operating conditions, would be of great help for designers and operators in order ...
T. Zouaghi, M. Poloujadoff
openaire   +1 more source