Results 71 to 80 of about 594,021 (280)

(INV6b-C2)/(DEL-90-C2) E17.5

open access: yes, 2018
Inversion of the genomic region (INV6b-C2) and Deletion of the genomic region (DEL-90-C2) analyzed at embryonic day E17.
Kazunori Sunadome (5396135)   +25 more
core   +2 more sources

Influence of physiological changes in endogenous estrogen on circulating PCSK9 and LDL cholesterol

open access: yesJournal of Lipid Research, 2015
Pharmacologically increased estrogen levels have been shown to lower hepatic and plasma proprotein convertase subtilisin/kexin type 9 (PCSK9) levels in animals and humans.
Moumita Ghosh   +3 more
doaj   +1 more source

Microstructure Evolution of a VMnFeCoNi High‐Entropy Alloy After Synthesis, Swaging, and Annealing

open access: yesAdvanced Engineering Materials, EarlyView.
The synthesis and processing (rotary swaging and annealing) of the novel VMnFeCoNi alloy is investigated, alongside the estimation of the grain size effect on hardness. Analysis of a wide grain size range of recrystallized microstructures (12–210 µm) reveals a low annealing twin density.
Aditya Srinivasan Tirunilai   +6 more
wiley   +1 more source

Cellular effects of a turmeric root and rosemary leaf extract on canine neoplastic cell lines

open access: yesBMC Veterinary Research, 2017
Background The use of nutraceuticals is gaining in popularity in human and canine oncology with a relatively limited understanding of the effects in the vastly different tumor types seen in canine oncology. We have previously shown that turmeric root (TE)
Corri B. Levine   +3 more
doaj   +1 more source

C1-C2 fusion: postoperative C2 nerve impingement—is it a problem? [PDF]

open access: yesEvidence-Based Spine-Care Journal, 2012
 The purpose of this comparison case study is to show a potential complication associated with atlantoaxial fusion, and the preoperative evaluation that could help to avoid it. The use of lateral mass screw fixation in atlantoaxial fusion has provided surgeons the ability to create rigid fixation, with a high success rate of fusion.
Myers, Kurt D.   +3 more
openaire   +2 more sources

B16-luc, LLC1-luc, TRAMP-C2-luc and microsphere dissemination (7 and 16 μm diameter) in soft tissues.

open access: yes, 2016
(A) Individual lung dissemination of tumor cells varied between ~30–40%. In contrast, very few microbeads (independent of their size) were found in the lung. All cell types disseminated significantly higher to the lung compared to microbeads (B16-luc vs.
Christian J. Hoffmann (3107976)   +5 more
core   +1 more source

Predictability of painful stimulation modulates the somatosensory-evoked potential in the rat [PDF]

open access: yes, 2013
Somatosensory-evoked potentials (SEPs) are used in humans and animals to increase knowledge about nociception and pain. Since the SEP in humans increases when noxious stimuli are administered unpredictably, predictability potentially influences the SEP ...
Schaap, M.W.H.   +6 more
core   +1 more source

Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy

open access: yesAdvanced Engineering Materials, EarlyView.
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang   +10 more
wiley   +1 more source

Cultivation of Diverse Type I and Type II Methanotrophs from Tropical Wetlands in India, Including Rare Taxa (Methylocucumis and Methylolobus)

open access: yesMethane
Wetlands are the most important natural sources of methane. Studies on the distribution and diversity of methanotrophs, especially in tropical wetlands, are limited.
Kajal Pardhi   +7 more
doaj   +1 more source

External and Internal Cracking Caused by Heat Treatment in Laser Powder Bed Fusion‐Fabricated Inconel 738LC Components

open access: yesAdvanced Engineering Materials, EarlyView.
Manufacturing problems such as heat treatment‐induced cracking hinder the widespread application of the laser powder bed fusion (LPBF) process to superalloys. In this study, cracks in the LPBF components of Inconel 738LC superalloy are characterized after heat treatment at various temperature ranges, revealing two distinct cracking behaviors.
Kosuke Kuwabara   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy