Results 71 to 80 of about 11,738 (294)
Finite Volume Simulation Framework for Die Casting with Uncertainty Quantification
, 2018 The present paper describes the development of a novel and comprehensive computational framework to simulate solidification problems in materials processing, specifically casting processes.
Aluru, Narayana +4 more
core +1 more source
Rib‐Reinforced Ultralight and Ultra‐Strong Shell Lattices
Advanced Science, EarlyView.This study thoroughly reveals the relation between the curvature and stress direction of triply periodic minimal surface (TPMS) thin shell lattices and proposes a novel rib reinforcement design strategy to incorporate ribs along the line of asymptotes (LOA) and the line of principal curvatures (LOC) to enhance the strength of ultralight TPMS shell ...
Winston Wai Shing Ma +6 more
wiley +1 more source
Angewandte Chemie, EarlyView.Schematic representation of M@E@CF nanosensors for detecting vesicular storage and release in cholinergic neurons and brain organoids. (A) Nano‐tip microelectrodes modification via molds fabricated through 3D printing. (B) the reaction mechanism for acetylcholine detection at the electrode interface.
Wanying Zhu +11 more
wiley +2 more sources
Latin American Journal of Solids and StructuresCurrently, there are a lot of research activities dealing with gamma titanium aluminide (γ-TiAl) alloys as new materials for low pressure turbine (LPT) blades.
Christian Dresbach +7 more
doaj +1 more source
Atomistic Simulations of Basal Dislocations Interacting with Mg$_{17}$Al$_{12}$ Precipitates in Mg [PDF]
, 2019 The mechanical properties of Mg-Al alloys are greatly influenced by the complex intermetallic phase Mg$_{17}$Al$_{12}$, which is the most dominant precipitate found in this alloy system.
Bitzek, Erik +4 more
core +1 more source
Cyclic plasticity and strain localization in cast γ-TiAl based alloy
Procedia Engineering, 2011 Abstract Cyclic strain localization and observation of surface relief in nearly lamellar cast γ-TiAl based alloy Ti–48Al–2Nb–2Cr–0.82B (all in at. %) cycled in strain control were experimentally studied. Hysteresis loop area, the cyclic hardening curves, the cyclic stress-strain curve and V H parameter were measured.
Petrenec, M., Polák, J., Buček, P.
openaire +1 more source
Advanced Science, EarlyView.This study combines full‐field tomography with diffraction mapping to quantify radial (ε002$\varepsilon _{002}$) and axial (ε100$\varepsilon _{100}$) lattice strain in wrinkled carbon‐fiber specimens for the first time. Radial microstrain gradients (−14.5 µεMPa$\varepsilon \mathrm{MPa}$−1) are found to signal damage‐prone zones ahead of failure, which ...
Hoang Minh Luong +7 more
wiley +1 more source
Formation and growth mechanism of the α2 lath within the γ phase in high Nb containing TiAl alloy
Journal of Materials Research and TechnologyA high Nb containing TiAl alloy exhibiting near fully lamellar microstructure with nano-lamellar spacing was obtained via heat treatment. The lamellar structure exhibits an average spacing of approximately 75 nm and comprises both γ/α₂ and γ/γ interfaces.
Gengwu Ge +4 more
doaj +1 more source
Advanced Science, EarlyView.Few‐layer La2CoO4 nanosheets are produced via phonon‐resonance‐assisted cleavage of the rock‐salt layers in the Ruddlesden‐Popper structure under the 20 kHz resonance condition, enabling controlled exfoliation into ultrathin sheets. The nanosheets show improved gas‐sensing capability, delivering an 86.67% response to 1 ppm NO2 at room temperature ...
Yi Liang +13 more
wiley +1 more source
Directionally solidified eutectic gamma-gamma nickel-base superalloys [PDF]
, 1977 A directionally solidified multivariant eutectic gamma-gamma prime nickel-base superalloy casting having improved high temperature properties was developed.
Jackson, M. R.
core +1 more source