Results 21 to 30 of about 43,291 (268)
MetalMatThe scanning electron microscope equipped with an energy dispersive spectroscopy (SEM/EDS) is considered as a state‐of‐the‐art characterization tool to determine the morphological features and the chemical composition of non‐metallic inclusions in steel.
Shashank Ramesh Babu +1 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Research in Agricultural Engineering, 2012 The dynamic coefficient of friction of single potatoes was determined on mild steel, rubber and plastic, for tubers in each of four conditions: dry and dirty, wet and dirty, clean and wet and clean and dry.
C.F.H. Bishop +3 more
doaj +1 more source
Investigation and study on the novel method of preparing Al-V alloy by electrode assisted heating
Journal of Materials Research and Technology, 2020 A novel method was developed to produce Al-V alloy electrode assisted heating (EAH) technology. The experimental results showed that the cracks in the alloy were significantly reduced and the distribution of the Al8V5 is significantly changed in the ...
Li Wang +7 more
doaj +1 more source
Integration of Open Slag Bath Furnace with Direct Reduction Reactors for New-Generation Steelmaking
Metals, 2022 The present paper illustrates an innovative steel processing route developed by employing hydrogen direct reduced pellets and an open slag bath furnace.
Pasquale Cavaliere +4 more
doaj +1 more source
Steeling the race: ‘Green steel’ as the new clean material in the automotive sector [PDF]
, 2022 This paper aims to examine consumer behaviour towards, and the willingness to adopt, ‘green steel’ in the automotive sector. Semi-structured interviews were held with experts from global, regional and country-specific industry associations and automakers.
Muslemani, Hasan +4 more
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Research on Rolling Contact Fatigue Mechanism of High Clean Bearing Steel GCr15
Teshugang, 2023 Through the standard detection and rating the metallurgical quality of the high clean bearing steel prepared by vacuum degassing process， such as chemical composition， macrostructure， carbide inhomogeneity and non-metallic inclusions， and quantitative ...
Yin Qing +5 more
doaj
Rancang Bangun dan Uji Performansi Alat Penyiang Gulma pada Tanaman Kacang Tanah
Rona Teknik Pertanian, 2012 Weeds were plants whose presence was undesirable because it lowered the yield of agricultural land that could be achieved by the production plant. Weeding the groundnut crop had been done conventionally, weeding method had many drawbacks.
Muhammad Dhafir +2 more
doaj +1 more source