Results 111 to 120 of about 214,349 (248)
Software Design of Secondary Programmable and Debugging Development for Converter
Customers’ ability in secondary programmable and debugging development plays an important role in converter industry with requirements of lower cost and celerity.
罗凌波, 戴计生, 尚敬
doaj
Unique biological samples, such as site‐specific mutant proteins, are available only in limited quantities. Here, we present a polarization‐resolved transient infrared spectroscopy setup with referencing to improve signal‐to‐noise tailored towards tracing small signals. We provide an overview of characterizing the excitation conditions for polarization‐
Clark Zahn, Karsten Heyne
wiley +1 more source
Research on the Ripple Current of Support Capacitor for DC Bus
Ripple current of support capacitor for DC bus in converter is one of the key factors affecting lifetime of the converters. In industrial processes, in order to save energy, expand capacity, optimize design, multi-motors sharing one DC bus structure is ...
YING Ting +3 more
doaj
The imminent depletion of oil resources and increasing environmental pollution have driven the use of clean energy, particularly wind energy. However, wind turbines (WTs) face significant challenges, such as critical component failures, which can cause ...
Joel Torres-Cabrera +5 more
doaj +1 more source
Time‐resolved X‐ray solution scattering captures how proteins change shape in real time under near‐native conditions. This article presents a practical workflow for light‐triggered TR‐XSS experiments, from data collection to structural refinement. Using a calcium‐transporting membrane protein as an example, the approach can be broadly applied to study ...
Fatemeh Sabzian‐Molaei +3 more
wiley +1 more source
Application of predictive control to a three-phase NPC converter: from simulation to a real platform [PDF]
This final degree thesis is concerned with the application of the Predictive Control with Multilevel Converters, specifically the application of the Finite Set Model Predictive Control (FS-MPC) in a Three-Level Neutral Point Clamped (3L-NPC) Inverter.
Bassan, Nicola
core
A Synchronization Control System for Converters Based on FPGA
To avoid problems of PWM edge jitter and sampling offset in the asynchronous control system of converters, this paper proposed a design scheme for synchronous control system of converters based on FPGA. The proposed scheme, which uses FPGA as the core of
LI Miao, QIU Yuefeng, ZHANG Shaoyun
doaj
This protocol paper outlines methods to establish the success of a time‐resolved serial crystallographic experiment, by means of statistical analysis of timepoint data in reciprocal space and models in real space. We show how to amplify the signal from excited states to visualise structural changes in successful experiments.
Jake Hill +4 more
wiley +1 more source
Design of the Yaw System for 2 MW Wind Turbine Based on 8400 StateLine Converter
It presents the design and application of 8400 StateLine converter for 2 MW wind turbine. According to the characteristic requirements of the wind turbine yaw system, it detailedly introduces the design of hardware and software for the yaw control system.
XU Xiongwei +5 more
doaj
Optimizing photoactivation of PA‐mCherry for optical pooled CRISPR screens
Photoactivatable PA‐mCherry finds widespread use to optically tag individual cells. However, confocal 405 nm UV laser‐scanning (normal scan) is much less efficient than widefield UV illumination, limiting the use of PA‐mCherry on confocal instruments. We remedy this limitation by reporting that rapid and repeated confocal scanning with a low‐intensity,
Sravasti Mukherjee +3 more
wiley +1 more source

