Results 91 to 100 of about 1,558,331 (296)
One-Step Hybrid Bending/Diffusion Bonding Process and Analysis of the Bonding Characteristics of Titanium Alloy Sheets. [PDF]
Materials (Basel), 2023 Kim KH +5 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.CT‐based finite element simulations combined with in situ X‐ray computed tomography are used to analyze insert pull‐out in nickel‐coated polymer foams. Despite variations in material parameters, deformation consistently concentrates within a narrow annular region around the insert.
Yannik Bautz +4 more
wiley +1 more source
The technological impact of diffusion in nanopores [PDF]
, 2005 The impact of nanopore diffusion on the performance of adsorption separation processes is reviewed. Zeolite membrane processes and kinetically selective cyclic adsorption processes depend for their selectivity on differences in intracrystalline diffusion
Ruthven, Douglas M.
core +1 more source
Fabrication Routes for Ionic Conducting Fiber Strain Sensors
Advanced Engineering Materials, EarlyView.Ionic conducting fiber strain sensors (ICFSs) offer compliant, textile‐integrable sensing. Thus far, the commercialization of ICFSs has been constrained by fiber fabrication routes. This review provides a fabrication‐centric analysis of ICFSs correlating processing strategies with material properties and scalability.
Leo John Kershaw +3 more
wiley +1 more source
, 1999 Diffusion bonding is a process where two surfaces are brought into contact, and under heat and pressure, the surfaces are bonded together. This process is most often associated with a superplastic forming operation where diffusion bonding is used to ...
Van Aken, David C.
core +1 more source
Effect of the Diffusion Bonding Conditions on Joints Strength
Journal of Engineering and Sustainable Development, 2009 In this research the effect of different parameters on the strength of joints which bonded by using diffusion bonding process has been studied. The specimens of copper and nickel were annealed in a vacuum furnace at (800 ºC). Specimens of Cu and Ni were
Zeyad D. Kadhim +2 more
doaj
Transient Liquid Phase Diffusion Bonding of Ni3Al Superalloy with Low-Boron Nickel-Base Powder Interlayer. [PDF]
Materials (Basel), 2023 Wen Z +7 more
europepmc +1 more source
Rapidly Solidified High‐Strength Invar 36 Prepared by Planar‐Flow Melt Spinning
Advanced Engineering Materials, EarlyView.The Invar 36 alloy was rapidly solidified using the planar‐flow melt‐spinning technique. Ribbon samples with thicknesses ranging from 20 to 160 mm were produced. As the grain size of the ribbon decreased to sub‐micron levels, the hardness increased by more than 2 times.
Bekir Akgül, Mehmet Kul
wiley +1 more source
Modeling brain extracellular space from diffusion data [PDF]
, 2007 The extracellular space (ECS) of the brain is a thin region surrounding each cell that is filled with a medium resembling cerebrospinal fluid and an unknown amount of extracellular matrix. The ECS is difficult to study but diffusion measurements based on
Nicholson, Charles
core +1 more source
Advanced Engineering Materials, EarlyView.HEA interlayers offer a versatile route for joining high‐performance structural materials. Their compositional and structural design regulates interfacial reactions, suppresses brittle IMCs, and improves metallurgical bonding. Sandwich interlayers further integrate defect healing with precipitation strengthening, enabling improved strength–ductility ...
Lin Yuan +4 more
wiley +1 more source