Results 1 to 10 of about 172,409 (305)
Influences of Atmospheric Humidity on Sliding Speed Characteristics of Dry Sliding Phenomena
Tribology Online, 2023 The effect of adsorbed water layers in sliding phenomena has been widely recognized, but it has yet to be explained thoroughly after many years of research.
Wei Chee Hong +2 more
doaj +2 more sources
Dry Sliding Wear Performance of ZA27/SiC/GraphiteComposites [PDF]
Metals, 2019 The paper describes the wear performance of zinc-aluminium ZA27 alloy, reinforced with silicon-carbide (SiC) and graphite (Gr) particles. The compo-casting technique produced the composite samples.
Nenad Miloradović +3 more
doaj +3 more sources
Influence of the ringer's solution on wear of vacuum mixed poly(methyl methacrylate) bone cement in reciprocating sliding contact with AISI 316l stainless steel [PDF]
Hemijska Industrija, 2021 This paper presents microstructural properties and damage behaviour of a vacuum mixed poly(methyl metacrylate) (PMMA) bone cement, during the sliding contact with AISI 316L stainless steel, under micro-loads.
Živić Fatima +4 more
doaj +1 more source
Lubricants, 2021 The coating materials commonly used in hydrodynamic bearings are the so-called “Babbitt metals” or “white metals”, as defined by ASTM B23-00. Their low Young’s modulus and yield point have encouraged researchers to find new coatings to overcome these ...
Davide Massocchi +4 more
doaj +1 more source
Lubricants, 2023 To improve the tribological characteristics of materials employed in spatial mechanisms, there is a significant requirement to develop solid lubricating composites with superior performance.
Jinming Zhen +6 more
doaj +1 more source
Sliding Friction on Wet and Dry Sand [PDF]
Physical Review Letters, 2014 We show experimentally that the sliding friction on sand is greatly reduced by the addition of some-but not too much-water. The formation of capillary water bridges increases the shear modulus of the sand, which facilitates the sliding. Too much water, on the other hand, makes the capillary bridges coalesce, resulting in a decrease of the modulus; in ...
Fall, Abdoulaye +7 more
openaire +4 more sources
High Temperature Friction and Wear Behavior of PTFE/MoS2 Composites
Lubricants, 2023 High performance polymer matrix composites with low friction and wear rate are of urgent requirement in sliding bearings and gaskets. In this study, the PTFE/MoS2 composites were prepared and the effect of testing temperature on the tribological ...
Jinming Zhen +7 more
doaj +1 more source
Lubricants, 2022 The friction coefficient is one of the key parameters in the tribological performance of mechanical systems. In the condition of light normal load and low rotation speed, the friction coefficients of ball-on-disc with rough surface in dry sliding contact
Qi Wen +3 more
doaj +1 more source
Tribological Performance of Self-lubricating Cast Al-5Cu-1Mg Nanocomposite Reinforced with Graphene Nano Sheets [PDF]
Iranian Journal of Materials Science and Engineering, 2023 This study was undertaken to investigate the influence of graphene nano sheets on the structural characteristics and dry sliding wear behaviour of Al-5Cu-1Mg aluminium alloy.
Mohammad Alipour
doaj
An investigation on dry sliding wear behavior of Al6061/ Titanium carbide/ Basalt hybrid metal matrix composites [PDF]
INCAS Bulletin, 2021 Dry sliding wear plays an important role in selecting material for automotive and aerospace applications. Researchers have been exploring novel aluminum matrix composites (AMC), which offer minimum wear rate for various tribological applications.
P. MUTHU
doaj +1 more source