Results 11 to 20 of about 1,058,340 (242)
Sliding wear of nitrided steels [PDF]
, 1993 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.The unlubricated sliding wear behaviour of gas nitrided, plasma nitrided, and ferritic nitrocarburized BS970,905M39 (EN41B) steels was investigated ...
Kato, Hirotaka
core +7 more sources
Wear maps for TiC composite based coatings deposited on 303 stainless steel [PDF]
, 2014 Dry sliding wear (pin-on-disc) tests were carried out under ambient conditions at room temperature for TiC coated and uncoated 303 stainless steel, using alumina as a counterface.
Rasool, Ghulam +3 more
core +4 more sources
Similarity solutions for unsteady shear-stress-driven flow of Newtonian and power-law fluids : slender rivulets and dry patches [PDF]
, 2011 Unsteady flow of a thin film of a Newtonian fluid or a non-Newtonian power-law fluid with power-law index N driven by a constant shear stress applied at the free surface, on a plane inclined at an angle α to the horizontal, is considered.
Wilson, Stephen +5 more
core +4 more sources
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2015 We investigated the effect of magnesium carbonate and rosin powders, conventionally used as anti-slip agents, for the ease of controlling the sliding motion of a stainless steel bar grasped vertically by a hand wearing a rubber glove.
Takeshi YAMAGUCHI, Kazuo HOKKIRIGAWA
doaj +1 more source
Tribological Performance of Self-lubricating Cast Al-5Cu-1Mg Nanocomposite Reinforced with Graphene Nano Sheets [PDF]
Iranian Journal of Materials Science and Engineering, 2023 This study was undertaken to investigate the influence of graphene nano sheets on the structural characteristics and dry sliding wear behaviour of Al-5Cu-1Mg aluminium alloy.
Mohammad Alipour
doaj
TEM characterisation of near surface deformation resulting from lubricated sliding wear of aluminium alloy and composites [PDF]
, 2007 Aluminium alloy composites have been extensively investigated for use in tribo-contact applications, however little detailed literature exists on the sub-surface microstructural evolution as a result of lubricated sliding wear.
Rainforth, W.M. +7 more
core +1 more source
Journal of Magnesium and Alloys, 2017 The friction and wear behaviors of biodegradable Mg-6Gd-0.5Zn-0.4Zr (wt%, GZ60K) alloy were evaluated under simulated body fluid (SBF) condition using ball-on-disk configuration and compared with those under dry sliding condition.
Jianwei Dai +5 more
doaj +1 more source
Analysis of a dry friction problem under small displacements: application to a bolted joint [PDF]
, 2003 This study presents an analysis of the problem of macroscopic contact of steel upon steel with dry friction, in the specific case of a bolted joint. The configurations of these types of joints result in very small displacements and interface sliding ...
Barrau, Jean-Jacques +8 more
core +1 more source
ASSESSMENT OF TRIBOLOGICAL BEHAVIOUR OF ZA-27 ZINCALUMINIUM ALLOY BASED NANOCOMPOSITE [PDF]
Proceedings on Engineering Sciences, 2019 Mechanical and tribological investigation of obtained nanocomposites is presented in this paper. As matrix material, well known tribological zinc-aluminium alloy, ZA-27 was used.
Dragan DžUNIĆ +6 more
doaj +1 more source
Mekanika, 2019 Brake pad is one of the components of a motor vehicle which is served to slow or stop the rate of vehicle. The brake pad of automotive vehicle on the market is divided into three types that are an OEM (original equipment manufacturer), OES (original ...
Rovilla Kennedy +2 more
doaj +1 more source