Results 51 to 60 of about 198,542 (401)
Mathematics, 2020 Technological tables are very important in electrical discharge machining to determine optimal operating conditions for process variables, such as material removal rate or electrode wear.
C. J. Luis Pérez
doaj +1 more source
Traveling wire electrode increases productivity of Electrical Discharge Machining /EDM/ equipment [PDF]
, 1967 Traveling wire electrode on electrical discharge machining /EDM/ equipment reduces the time requirements for precision cutting. This device enables cutting with a minimum of lost material and without inducing stress beyond that inherent in the material ...
Kotora, J., Jr., Smith, S. V.
core +1 more source
Advanced Engineering Materials, EarlyView.This work reveals the phase composition and quantitative morphology analysis of precipitation‐hardened Fe32Cu12Ni11Ti16Al29 complex‐concentrated alloy. The precipitates are shown to have a high coherency. Morphology transition between sphere, cuboidal, and elongated morphology is observed. Finally, the overaging behavior is captured using microhardness.
Rostyslav Nizinkovskyi +4 more
wiley +1 more source
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2011 In this paper, we report on the co-operative control of a 5-DOF controlled magnetically-levitated (maglev) local actuator (MLA) combined with a conventional electrical discharge machine, which we developed as a means to increasing the electrical ...
Dongjue HE +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.In the present study, metastable CrMnNi steels with varying chemical compositions and a concomitantly altered stacking fault energy are processed via directed energy deposition and afterwards tested via tensile tests at different temperatures. The present study shows the influence of the manufacturing process on the elemental deformation mechanisms for
Julia Richter +8 more
wiley +1 more source
Advances in Mechanical Engineering, 2017 The mechanism of surface topography formation of Inconel 718 in low-speed wire electrical discharge machining was studied, and its on-line prediction based on acoustic emission detection technology is carried out.
Yan Wang, Duxing He, Lin Yang, Wei Xiong
doaj +1 more source
EXPERIMENTAL EVALUATION OF WEDM MACHINED SURFACE WAVINESS
Acta Polytechnica, 2016 Wire Electrical Discharge Machining (WEDM) an unconventional machining technology which has become indispensable in many industries. The typical morphology of a surface machined using the electrical discharge technology is characterized with a large ...
Katerina Mouralova +2 more
doaj +1 more source
Kesan latihan dalam perkhidmatan ke atas kualiti pengajaran dam pembelajran dalam bidang teknik dan vokasional [PDF]
, 2006 Kajian ini bertujuan untuk mengenalpasti keberkesanan latihan dalam perkhidmatan yang dihadiri oleh guru-guru teknik dan vokasional dan sejauh mana hubungannya dengan keberkesanan pengajaran mereka dan pencapaian pelajar.
Razali, Hairani
core
Advanced Engineering Materials, EarlyView.The influence of Hot Isostatic Pressing (HIP) temperature on the microstructure and creep performance of powder bed fusion–laser beam processed CM247LC superalloy is investigated. Grain growth and γ’ precipitate evolution are characterized following HIP at varying temperatures.
Ahmed Fardan +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Fe–12Mn–0.2C medium‐manganese steel is processed by laser‐based powder bed fusion of metals using blended as well as pre‐alloyed powder. Various scanning speeds are used to determine the influence of energy deposition rate on microstructure and mechanical properties.
Leoni Hübner +4 more
wiley +1 more source