Results 41 to 50 of about 1,028 (195)

Investigation on flat torque‐angle characteristic of torque motor based on magnetic saturation of tooth tip

open access: yesIET Power Electronics, Volume 16, Issue 3, Page 357-374, 19 February 2023., 2023
Abstract The flat torque‐angle characteristic of torque motor plays a decisive role in the control quality of electro‐hydraulic servo and proportional valve. To solve the issue that the current wet‐type torque motor for two‐dimensional (2D) valve does not have flat torque‐angle characteristic, a method for adjusting the flat torque‐angle characteristic
Bin Meng   +5 more
wiley   +1 more source

Modelling, transient response and hydraulic behaviour of 2DOF stabilization platform [PDF]

open access: yesFME Transactions, 2020
The main part of the hydraulic circuit of the hydraulic stabilization platform (HSP) is the electro-hydraulic servo valve (EHSV), which is very expensive due to its manufacturing requirements, so the proper selection for the geometrical configuration of ...
Ibrahim Ezz Eldin   +3 more
doaj  

Performance Improvement of a Conventional Hydraulic Elevator by Using Electro-Hydraulic Servo Mechanism [PDF]

open access: yesEngineering and Technology Journal, 2020
An electro-hydraulic elevator is a new type of enhanced elevators that are used in low-rise buildings that do not exceed more than three floors. In this paper, an electro-hydraulic servo system for controlling the speed of a hydraulic elevator prototype ...
Jamal Mohammed   +2 more
doaj   +1 more source

Development of Hydraulically Driven Fatigue Testing Machine for Insulators

open access: yesIEEE Access, 2018
The hydraulically driven fatigue testing machine is studied to simulate the vibration in the fatigue experiments for the insulators. First, hydraulic scheme and control principle are introduced.
Jianlin Xuan, Shoukun Wang
doaj   +1 more source

Design and Analysis of Combined Valve Spool with Linear Flow Coefficient

open access: yesJournal of Engineering, 2022
The orifice flow model is generally established based on the turbulent state, and the flow discharge is considered to be a constant value. In fact, the flow discharge has obvious nonlinearity under the condition of small opening and small pressure ...
Changxiong Xie   +3 more
doaj   +1 more source

Investigation of a Digital Hydraulic Valve Operated by Servo Motors

open access: yes, 2021
This paper describes a new type of digital hydraulic valve run by two servo motors. Digital hydraulics is a cutting edge technology, which saves more exhausted energy than conventional hydraulic valves.
Cetin, Muhammet Huseyin   +7 more
core   +3 more sources

Present Status and Prospect of High-Frequency Electro-hydraulic Vibration Control Technology

open access: yesChinese Journal of Mechanical Engineering, 2019
Electro-hydraulic vibration equipment (EHVE) is widely used in vibration environment simulation tests, such as vehicles, weapons, ships, aerospace, nuclear industries and seismic waves replication, etc., due to its large output power, displacement and ...
Yi Liu   +3 more
doaj   +1 more source

Research on high efficiency and high dynamic optimal matching of the electro-hydraulic servo pump control system based on NSGA-II

open access: yesHeliyon, 2023
An electro-hydraulic servo pump control system (hereinafter referred to as EHSPCS) is a volume servo control unit that is highly integrated with servo motors, fixed-displacement pumps, hydraulic cylinders and functional valve groups.
Mingkun Yang   +4 more
doaj   +1 more source

Meta‐Rod Mechanical Metamaterials With Programmable Reconfiguration

open access: yesAdvanced Functional Materials, Volume 36, Issue 40, 18 May 2026.
Existing mechanical metamaterials achieve programmable large deformations in planar square or cubic configurations, restricted by required complex boundary conditions. This research proposes a 1D metamaterial, Meta‐rod, with linear, bending, twisting, area, and volume deformation modes.
Atharva Pande, Lyes Kadem, Hang Xu
wiley   +1 more source

Research on High-Precision Position Control of Valve-Controlled Cylinders Based on Variable Structure Control

open access: yesMachines, 2023
During the operation of valve-controlled cylinder position systems, there are some problems, such as uncertainty and time-varying of the system parameters, imprecise modeling, and external interference.
Bingwei Gao   +3 more
doaj   +1 more source

Home - About - Disclaimer - Privacy