Results 41 to 50 of about 55,095 (303)
Microstructure Effects of the Electrical Discharge Machining Drill on Aerospace Super Alloys
Advances in Materials Science and Engineering, 2022 This paper presents an analysis of the parent material damage and electrode wear of a handheld electrical discharge machining (EDM) drill. The motivation of this study is to investigate the material effects of EDM drilling on aerospace alloys at a ...
Garner Copher +6 more
doaj +1 more source
Micro-Drilling of Sapphire Using Electro Chemical Discharge Machining
Micromachines, 2020 Electrochemical discharge machining (ECDM) refers to a non-traditional machining method for performing effective material removal on non-conductive hard and brittle materials.
Chao-Ching Ho, Jia-Chang Chen
doaj +1 more source
Comparative experimental investigation and gap flow simulation in electrical discharge drilling using new electrode geometry [PDF]
Mechanical Sciences, 2017 This study presents experimental and numerical investigation on the effectiveness of electrode geometry on flushing and debris removal in Electrical Discharge Drilling (EDD) process.
A. T. Bozdana, N. K. Al-Karkhi
doaj +1 more source
Advanced Engineering Materials, EarlyView.A carbon‐free, as‐sintered MgO–steel cermet anode, fabricated via cold isostatic pressing using MgO–C refractory recyclate, was evaluated under laboratory‐scale K‐cryolite electrolysis at 800°C. Operation at this reduced temperature, combined with the electrolyte's limited electrical conductivity, led to an increase in cell voltage.
Farhan Hossain +7 more
wiley +1 more source
Metals, 2023 Electrical discharge machining (EDM) is one of the important machining processes to produce mold components. When using the EDM process, surface quality, processing time, accuracy, and electrode cost must be considered.
Shih-Ming Wang +4 more
doaj +1 more source
Abrasive wear in wear plates and hard coatings applied by welding with shielded electrode
Revista Facultad de Ingeniería, 2017 Performance against abrasive wear was evaluated (in compliance with the ASTM G-65 standard) for both wear plates and hard coatings applied by electric welding. The characterization of the coatings was achieved by using hardness tests, optical microscopy and scanning electron microscopy (SEM).
José Luddey Marulanda-Arévalo +2 more
openaire +6 more sources
Advanced Engineering Materials, EarlyView.This study reports lightweight polyetherimide triply periodic minimal surfaces lattices coated with carbon nanotube‐reinforced epoxy that combine mechanical robustness with self‐sensing. The conformal coating enhances stiffness, strength and energy absorption while enabling reliable strain monitoring.
A. Triay +3 more
wiley +1 more source
LubricantsResearch on the WEDM process has traditionally focused on analyzing discharge initiation, material removal mechanisms and surface formation from the perspective of the machined part.
Jarosław Buk +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Cladding is a proven method that boosts the surface qualities of mechanical parts by applying a layer of more durable material over a base substrate. This work responds to the needs of offshore and pressure vessels sectors by focusing on cladding a super austenitic steel onto low‐carbon steel through gas tungsten arc welding.
E. J. da Cruz Junior +6 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir +5 more
wiley +1 more source