Results 1 to 10 of about 53,208 (164)
Frontiers in Energy Research, 2022 The calculation method of the equivalent impedance and admittance parameters of the Gas Insulated Line (the Gas Insulated Line is abbreviated as GIL in this paper) grounded by the copper bar is studied and proposed.
Botong Li +4 more
doaj +3 more sources
Design of Internal Wire-Based Impedance Matching of Helical Antennas Using an Equivalent Thin-Wire Model [PDF]
International Journal of Antennas and Propagation, 2017 We propose a novel design of internal impedance matching networks for axial-mode helical antennas. This network comprises a single wire attached to the helix.
Slobodan V. Savić +2 more
doaj +2 more sources
Design of EM Sensor for Non-Contact Detection of Defective Wire Harness in Conveyor System
Sensors, 2022 For a non-contact detection of defective wire harness in conveyor system, a new method using the electromagnetic (EM) sensor is proposed in this paper. A dual-feed and multi array microstrip patch antenna operating at 5.8 GHz is utilized to design the EM
Hailin Zeng +3 more
doaj +1 more source
Вестник Самарского государственного технического университета. Серия: Технические науки, 2022 Overhead ground-wire cable (GW) is more prone to ice formation compared to 220 kV overhead lines. Ice-melting methods for GW using special power source have certain engineering constraints and required is connection of overhead line.
Evgenij A. Krotkov +2 more
doaj +1 more source
Mechanical Calculation of Flexible Wires of Spans with Different Tensioning Insulator Strings
Известия высших учебных заведений и энергетических объединенний СНГ: Энергетика, 2020 In design activities, technical solutions are practiced, which provide for the use of different tension strings of insulators in a single span. The present paper considers the calculation of the sag and load factors for a span with two different ...
Yu. V. Bladyko
doaj +1 more source
Equivalent circuit of a ferrite-wound inductor in a wide frequency range (0 Hz – 500 MHz)
Физика волновых процессов и радиотехнические системы, 2022 Based on the measured impedance of the inductors wound on various ferrite cores and with a different number of turns, an equivalent high frequency (0 Hz – 500 MHz) circuit model was built.
Vladimir F. Dmitrikov +1 more
doaj +1 more source
Equivalent Static Wind Loads on Snow-accreted Overhead Wires
Structural Engineering International, 2021 The effects of structural and aerodynamic non-linearity on dynamic wind loads on overhead wires have been investigated. According to the Japanese design standards for transmission structures, wind loads on overhead wires are determined using equivalent static wind loads that can be used to estimate the maximum responses under dynamic loads.
Hisato Matsumiya +4 more
openaire +3 more sources
Mechanical Calculation of Flexible Wires Loaded with Concentrated Loads
Известия высших учебных заведений и энергетических объединенний СНГ: Энергетика, 2020 Calculating of wires sag and tension under various modes is the task of mechanical calculation. The article derived formulas for the curve of the wire sag under the action of one or several concentrated forces and with various tensioning insulators ...
Y. V. Bladyko
doaj +1 more source
Antenna Current Calculation Based on Equivalent Transmission Line Model
Micromachines, 2022 This paper provides a new way for spatial current/field profiles for frequency-selective surface analytical approximation. It confirms that the per unit length radiation resistance of an equivalent transmission line model for line antenna has little ...
Shusheng Wei, Wusong Wen
doaj +1 more source
Литьë и металлургия, 2019 The parameters of wire production affecting the distribution of residual stresses and strains on the wire cross section are considered. It is determined that the modes of coarse drawing can affect the complex of mechanical properties of thin wire due to ...
Yu. L. Bobarikin, Yu. V. Martyanov
doaj +1 more source