Results 11 to 20 of about 1,066,022 (300)
Известия высших учебных заведений и энергетических объединенний СНГ: Энергетика, 2018 The objective of mechanical calculation of flexible wires of substations and overhead lines is to determine the sag and tension in different climatic conditions.
Yu. V. Bladyko
doaj +1 more source
Известия высших учебных заведений и энергетических объединенний СНГ: Энергетика, 2018 In the mechanical calculation of the flexible wires of substations and overhead lines, sags and tension are determined in various climatic conditions. Concentrated loads from spacers, barrier balls, stubs, taps to electrical apparatus and other elements ...
Y. V. Bladyko
doaj +1 more source
Comparison of actuation schemes for wire-driven parallel robots [PDF]
, 2013 There are two main systems that can be used to coil and uncoil the wires of a wire-driven parallel robots: a rotary motor that turns a drum on which the wire is coiled or a linear motor with a pulley system.
Merlet, Jean-Pierre
core +1 more source
Mechanical Calculation of Flexible Wires of Overhead Lines with Barrage Balls
Известия высших учебных заведений и энергетических объединенний СНГ: Энергетика, 2018 Aerial barrage balls serve for marking high-voltage wires in order to visually warn pilots of civil and military aviation about the presence of overhead lines.
I. I. Sergey, Y. V. Bladyko
doaj +1 more source
Equivalent circuit of an inductor on a nanocrystalline core with a high magnetic permeability
Физика волновых процессов и радиотехнические системы, 2022 Based on the measured impedance of the inductors based on a toroidal core wound from a thin (18 m) nanocrystalline tape, with a different number of winding turns, an equivalent high frequency (0 Hz - 500 MHz) circuit model was built.
Vladimir F. Dmitrikov +2 more
doaj +1 more source
Nonlinear isolation performance of 6 × 19 wire rope of different lengths under compression
Advances in Mechanical Engineering, 2021 Stainless steel wire rope isolator is widely used in engineering. To optimize design of the isolator, loading, and unloading characteristics of the 6 × 19 6 mm wire rope under compression are investigated. Ropes of different lengths are tested to get the
Genlin Mo +3 more
doaj +1 more source
XL. The Equivalent resistance and inductance of a wire to an Oscillatory Discharge [PDF]
The London, Edinburgh, and Dublin Philosophical Magazine and Journal of Science, 1897 n ...
openaire +3 more sources
On-Chip Transparent Wire Pipelining (invited paper) [PDF]
, 2004 Wire pipelining has been proposed as a viable mean to break the discrepancy between decreasing gate delays and increasing wire delays in deep-submicron technologies.
Casu, Mario Roberto, Macchiarulo, Luca
core +1 more source
Estimating the “Pull” on a Pullthrough Wire: A Pilot Study
EJVES Vascular Forum, 2021 Objective: Pullthrough/body floss wires are used to track endovascular devices across tortuous aorto-iliac anatomy encountered during endovascular repair of abdominal or thoracic aortic aneurysms.
Arindam Chaudhuri +2 more
doaj +1 more source
A key recovery attack on the 802.11b wired equivalent privacy protocol (WEP) [PDF]
ACM Transactions on Information and System Security, 2004 In this paper, we present a practical key recovery attack on WEP, the link-layer security protocol for 802.11b wireless networks. The attack is based on a partial key exposure vulnerability in the RC4 stream cipher discovered by Fluhrer, Mantin, and Shamir.
Adam Stubblefield +2 more
openaire +1 more source