Results 21 to 30 of about 1,066,022 (300)

Effect of Different Loading Conditions on the Service Life of Mine Steel Wire in Corrosive Medium

open access: yesInternational Journal of Electrochemical Science, 2016
Long-term corrosion test, constant tensile test and corrosion fatigue test of steel wire were carried out in this paper. According to the results of parameters of electrochemical corrosion, equivalent stress distribution of pit bottom, and morphology of ...
Songquan Wang   +3 more
doaj   +1 more source

On the accuracy of $N-1$ wire-driven parallel robots [PDF]

open access: yes, 2013
A $N-1$ wire-driven parallel robot is a robot for which all the $N \ge 3$ wires are connected at the same point of the platform, allowing to control the location of this point. We are interested in the positioning accuracy of such a robot.
Merlet, Jean-Pierre, Jean-Pierre Merlet
core   +1 more source

Equivalent-Circuit Model for Meta-Atoms Consisting of Wired Metallic Spheres [PDF]

open access: yesIEICE Transactions on Electronics, 2017
An equivalent-circuit model is an effective tool for the analysis and design of metamaterials. This paper describes a systematic and theoretical method for the circuit modeling of meta-atoms. We focus on the structures of wired metallic spheres and propose a method for deriving a sophisticated equivalent circuit that has the same topology as the wires ...
Takashi Hisakado   +3 more
openaire   +1 more source

The cold rolling of thin brass wire

open access: yes, 2022
S.362-365Today a process combining wire rolling and wire drawing is primarily employed for the production of thin wires with a diameter in the range of 1mm. Between the single process stages the material must be heat treated several times.
Schmitt, P., Konrad, T., Bark, C.
core   +1 more source

Advancing the performance of one-dimensional photonic crystal/photonic wire micro-cavities in silicon-on-insulator [PDF]

open access: yes, 2008
We present new results that demonstrate advances in the performance achievable in photonic crystal/photonic wire micro-cavities. In one example, a quality-factor value as high as 147,000 has been achieved experimentally at a useful transmission ...
Md Zain, A.R.   +2 more
core   +6 more sources

Calculation of Equivalent Resistance for Ground Wires Twined with Armor Rods in Contact Terminals

open access: yesEnergies, 2018
Ground wire breakage accidents can destroy the stable operation of overhead lines. The excessive temperature increase arising from the contact resistance between the ground wire and armor rod in the contact terminal is one of the main reasons causing the
Gang Liu   +5 more
doaj   +1 more source

Nonlinear Vibration Isolation via a NiTiNOL Wire Rope

open access: yesApplied Sciences, 2021
Vibration isolators with both stiffness and damping nonlinearities show promise for exhibiting compound advantages for broadband vibration isolation. A nonlinear isolator with a NiTiNOL wire rope is proposed with cubic stiffness, hysteretic damping, and ...
Mu-Qing Niu, Li-Qun Chen
doaj   +1 more source

RESEARCH ON STRESS AND DEFORMATION OF WR-CVT DISCONTINUOUS CONTACT STEEL ROPE UNDER TENSILE AND TORSIONAL LOADS

open access: yesJixie qiangdu, 2021
In this paper, the 3-D model of discontinuous contact of 2/3 lay length steel rope is established by ProE/5.0. Finite element analysis of discontinuous contact steel rope under axial tension and torsion load was carried out in ABAQUS.
ZHANG Wu   +4 more
doaj  

Equivalent circuit model of electromagnetic behaviour of wire objects by the matrix pencil method [PDF]

open access: yesSerbian Journal of Electrical Engineering, 2008
The electromagnetic behaviour of thin-wire objects is an important engineering problem. A general analysis of such objects is done according to the moment method approach within an antenna-based electromagnetic model.
Arnautovski-Toseva Vesna   +2 more
doaj   +1 more source

The Simple Equivalent of an Alternating Circuit of Parallel Wires [PDF]

open access: yesNature, 1909
IN NATURE of January 30, 1908, some results were quoted by me with reference to the effective inductance of two long parallel wires when the change of current distribution due to frequency is taken into account. These were extended later (Phil. Mag., February, 1909) to meet the case in which the wires are very close together.
openaire   +2 more sources

Home - About - Disclaimer - Privacy