Results 211 to 220 of about 104,411 (281)

Dimer models and conformal structures

Communications on Pure and Applied Mathematics, Volume 79, Issue 2, Page 340-446, February 2026.
Abstract Dimer models have been the focus of intense research efforts over the last years. Our paper grew out of an effort to develop new methods to study minimizers or the asymptotic height functions of general dimer models and the geometry of their frozen boundaries.
Kari Astala, Erik Duse, István Prause, Xiao Zhong   +3 more
wiley   +1 more source

Explicit correction of severely non-uniform distributions of cryo-EM views. [PDF]

Acta Crystallogr D Struct Biol
Barchet C, von Loeffelholz O, Bahena-Ceron R, Klaholz BP, Urzhumtsev AG.   +4 more
europepmc   +1 more source

Effect of the Strut Thickness on the Mechanical Properties, Deformation, and Failure Mechanisms of Vascular Bundle–Inspired Structures

Engineering Reports, Volume 8, Issue 2, February 2026.
The vascular bundle–inspired structure design involved developing a unit cell and rotating it by 45° for 2D/3D assembly. Unit cells varied in strut thickness (t) from 0.2 to 1.15 mm. Finite element model (FEM) analysis under quasi‐static compression yielded stress–strain curves and stress/strain maps.
Fredrick Mwema, Ndivhuwo Ndou
wiley   +1 more source

LSWM: A Long-Short History World Model for Bipedal Locomotion via Reinforcement Learning. [PDF]

Biomimetics (Basel)
Xue J, Liang Z, Mou H, Li Q, Zhang J.
europepmc   +1 more source

Adaptive Fuzzy PID Control of Two‐DOF Pneumatic Artificial Muscle Manipulators for Leg Rehabilitation

Engineering Reports, Volume 8, Issue 2, February 2026.
Two‐degree‐of‐freedom manipulator driven by PAM. ABSTRACT Rehabilitation robots are machines that allow patients to perform practice movements and ought to be sufficiently compliant for safe human interaction. Most robots today use hydraulic systems and continually rotating servo motors, making them less suitable for rehabilitation.
Solomon Ferede Ezez, Chala Merga Abdissa, Melkamu Bekele Leza   +2 more
wiley   +1 more source

Research on the design of overall stability capacity for axial compression and single sided connected eccentric compression equal leg angles. [PDF]

Sci Rep
Han J, Zhang W, Yang L.
europepmc   +1 more source

Finite Element‐Based Wear Prediction Using Archard's Law for Single Mobility Bearing of Total Hip Prosthesis During Walking: A Literature Review

Engineering Reports, Volume 8, Issue 2, February 2026.
This review provides a comprehensive and critical evaluation of computational wear prediction studies in total hip prostheses, with a specific focus on those employing Archard's wear law within finite element frameworks under walking conditions for single mobility bearing designs.
Muhammad Imam Ammarullah, Abdulfatah Abdu Yusuf, Mohamad Izzur Maula, M. Danny Pratama Lamura, Budi Setiyana, Mohammad Tauviqirrahman, Athanasius Priharyoto Bayuseno, Jamari Jamari, Muhammad Hanif Ramlee   +8 more
wiley   +1 more source

A Study of a GNSS/IMU System for Object Localization and Spatial Position Estimation. [PDF]

Sensors (Basel)
Miletiev R, Petkov PZ, Yordanov R.
europepmc   +1 more source

Improving the Characteristics of the Direct FOC Strategy in DFIG‐Based Wind Turbine Systems Using FOIDD and FOPD Controllers

Energy Science &Engineering, Volume 14, Issue 2, Page 999-1021, February 2026.
This study presents a new control strategy for doubly fed induction generator (DFIG) wind turbine systems to overcome the limitations of traditional direct field control using proportional‐integral (DFOC‐PI) regulators, which are sensitive to coefficient changes and lead to low power quality.
Hamza Gasmi, Habib Benbouhenni, Z. M. S. Elbarary, Ilhami Colak, Tahar Tafticht, Salman Arafath Mohammed   +5 more
wiley   +1 more source

Single-Crystal NMR for ¹⁷O in Alanine Enantiomers. [PDF]

ACS Phys Chem Au
Agarwal S, Wi S, Kitchen J, Li Z, Taylor CJ, Famiano MA, Miller JB.   +6 more
europepmc   +1 more source