Results 81 to 90 of about 47,448 (240)
Purpose: to analyze the effect of eyelid hygiene and therapy on early post-op period following excimer laser refractive surgery.Methods: 144 patients (288 eyes) aged 18-57 yrs who underwent excimer laser vision correction (LASIK) were followed.
V. V. Kurenkov +3 more
doaj +3 more sources
Room Temperature Synthesis and Photopatterning of Mesoporous Titanium Dioxide Thin Films
A nanofabrication strategy combining deep‐UV photolithography with block copolymer self‐assembly enables direct patterning and mineralization of mesoporous TiO2 thin films at room temperature. Photocatalytic titanium oxo‐clusters promote polymer degradation under UV irradiation, enabling multiscale control over porosity, film thickness, and lateral ...
Youssef Ghossoub +5 more
wiley +1 more source
Nanoporous Microelectrodes for Neural Electrophysiology Recordings in Organotypic Culture
The highly porous microelectrodes have been designed and printed on culture membranes, allowing to record electrophysiological neural activity for rodent brain slices. To keep the biocompatible nanoporous structure, the microelectrodes and insulative layer are fabricated on the bottom of culture membranes with only small connector pads added on the top.
Petro Lutsyk +3 more
wiley +1 more source
Adjunctive strategies in the management of resistant, 'undilatable' coronary lesions after successfully crossing a CTO with a guidewire. [PDF]
Successful revascularisation of chronic total occlusions (CTOs) remains one of the greatest challenges in the era of contemporary percutaneous coronary intervention (PCI).
Fairley, SL +5 more
core +1 more source
ABSTRACT The combination of metasurfaces with chalcogenide phase‐change materials is a highly promising route toward the development of multifunctional and reconfigurable nanophotonic devices. However, their transition into real‐world devices is hindered by several technological challenges. This includes, amongst others, the lack of large area photonic
Carlota de Ruiz de Galarreta +8 more
wiley +1 more source
An excimer laser three-dimensional (3D) micromachining system is proposed based on a mask image projection method and the optical diffraction effect. The effects of optical diffraction on the laser machining rate are evaluated using a hole-arrayed mask ...
Yu-Hsuan Hung +2 more
doaj +1 more source
Ferroelectric phase stability in Hf₀.5Zr₀.5O2 films is enhanced by confinement to the (111) crystal orientation, as demonstrated by first‐principles calculations and experiments. Polarization approaching its maximum value is achieved through selective ferroelectric switching paths, which are further tuned by oxygen vacancies and cation doping to ...
Fatoye Sawyerr +14 more
wiley +1 more source
Purpose. To assess the state of the posterior segment of the eye, namely, the state of the pre-macular bursa and the density of the capillary network of the retina in the early postoperative period in patients with myopia and myopic astigmatism who was ...
V. D. Antonyuk +2 more
doaj +1 more source
A lithium‐bearing slag is investigated with the goal of holistic valorization. The present β‐eucryptite (LiAlSiO4) exhibits a high lithium content and low levels of impurities. The spinel contains most of the chromium and vanadium, representing additional valorization opportunities.
Peter Cornelius Gantz +9 more
wiley +1 more source
Room‐Temperature Antiferroelectricity in Titanite (CaTiSiO5) Thin Films
This study reports the first fabrication of titanite films featuring 1D chains of oxygen octahedra, along with the first observation of their antiferroelectric behavior at room temperature. A field‐induced ferroelectric phase is observed at ∼430 kV/cm, which is not reported in bulk titanite.
Weirong Yang +3 more
wiley +1 more source

