Results 21 to 30 of about 236,835 (279)
A study on surface cracking in extrusion of aluminium alloy AA2014 [PDF]
, 2004 Surface cracking is generally recognised as one of the main defects occurring during the process of aluminium extrusion, especially in the case of the so called hard aluminium alloys.
Sheppard, Terry, Peng, Z.
core +1 more source
Foods, 2023 This study investigated the optimal extrusion conditions required to produce an isolated pea protein (IPP)-based meat analog. High-moisture extrusion cooking (HMEC) was performed.
Yu Zhang, Gi Hyung Ryu
doaj +1 more source
The effect of pressure and temperature variations on the FEM prediction of deformation during extrusion [PDF]
, 2005 The extrusion process is complex, involving interaction between the process variables and the material’s high temperature properties and is typically conducted at relatively high temperatures because the lower flow stress of the material permits larger ...
Flitta, Isaac, Sheppard, Terry
core +1 more source
Rheology of semi-solid fresh cement pastes and mortars in orifice extrusion [PDF]
, 2013 Short fiber-reinforced semi-solid fresh cement pastes and mortars, tailored for extrusion, have much lower water-to-binder ratio and higher viscosity than normal cement pastes or mortars. The rheology of these pastes or mortars cannot be characterized by
Fan, Mizi +7 more
core +1 more source
Nanomaterials, 2021 Ni-based bimetallic films with 20 at.% and 45 at.% Cu and mesostructured surfaces were prepared by electrodeposition from an aqueous solution containing micelles of P123 triblock copolymer serving as a structure-directing agent.
Jingyuan Bai +10 more
doaj +1 more source
Precipitation behavior during re-aging of Al-Mg-Si-Cu alloy
Materials & Design, 2022 Nano-scaled L phase, β′′ phase, Q′ phase and their composite phases can effectively strengthen Al-Mg-Si-Cu alloys, and balance the mechanical properties and electrical conductivity.
Hongmei Jin, Di Tie, Renguo Guan
doaj +1 more source
Numerical modelling of the aluminium extrusion process when producing complex seactions. [PDF]
This thesis reports the analysis by FEM of both continuum and structural models describing the extrusion process. They were compared with experimental work and the agreement is satisfactory.
Longjang, Niu
core +5 more sources
Journal of Materials Research and Technology, 2023 Al–Cu–Mg–Fe–Ni alloys are widely used in high temperature structural materials such as automobile engine cylinders and pistons, owning to their good high temperature mechanical properties.
Zhou Yang +7 more
doaj +1 more source
(2ND REPORT) ON THE EXTRUSION PRESSURE OF THE EXTRUSION ALUMINIUM BY DIRECT EXTRUSION
Journal of Japan Institute of Light Metals, 1955 It is described the effect of many various factors on the extrusion pressure of pure aluminium by direct method as the same in the previous report. The results obtained are as follows:(1) Although the accurate measuring of min extrusion. pressure is difficult owing to hot working, max.
MORINAGA, TAKUICHI +3 more
openaire +2 more sources
NanomaterialsEffective absorption in the S-band usually requires relatively thick absorbing materials. However, growing application demands necessitate the development of high-performance materials with subwavelength thickness.
Hongxu Jin +5 more
doaj +1 more source