Results 231 to 240 of about 18,207 (263)
Some of the next articles are maybe not open access.
Responses of Resistive Superconducting-Fault-Current-Limiters to Unbalanced Faults
IEEE Transactions on Appiled Superconductivity, 2005We analyzed the unsymmetrical fault characteristics of resistive superconducting-fault-current-limiters (SFCL) based on YBCO thin films with the unbalanced faults such as a single line-to-ground fault, a double line-to-ground fault, and a line-to-line fault in a three-phase system. The unsymmetrical rates of fault phases were 6.4, 9.2, 8.8 at the fault
H.-S. Choi +6 more
openaire +1 more source
Modeling feedback bridging faults with non-zero resistance
The Eighth IEEE European Test Workshop, 2003. Proceedings., 2004We study the behavior of feedback bridging faults with non-zero bridge resistance in both combinational and sequential circuits. We demonstrate that a test vector may detect the fault, not detect the fault or lead to oscillation, depending on bridge resistance.
Ilia Polian +3 more
openaire +2 more sources
Aspects of the Development of Secure and Fault-Resistant Hardware
2008 5th Workshop on Fault Diagnosis and Tolerance in Cryptography, 2008Designing "secure hardware" like a chip card controller, is a challenging task for hardware manufacturers: More and more attacks that are also more and more sophisticated generate a need for more and more countermeasures. Developers of these devices have to live with certain additional constraints and this does not make their life easier.
openaire +1 more source
Automatic test pattern generation for resistive bridging faults
Proceedings. Ninth IEEE European Test Symposium, 2004. ETS 2004., 2004An ATPG for resistive bridging faults is proposed that combines the advantages of section-based generation and interval-based simulation. In contrast to the solutions introduced so far, it can handle arbitrary non-feedback bridges between two nodes, including ones detectable at higher bridge resistance and undetectable at lower resistance, and faults ...
Piet Engelke +3 more
openaire +3 more sources
Faulty resistance sectioning technique for resistive bridging fault ATPG systems
Proceedings 10th Asian Test Symposium, 2002This paper proposes a bridging fault resistance sectioning technique for high speed generation systems of test sets which detect all the resistive bridging faults detectable by logic testing, targeting all the resistive bridging faults each of which ranges from zero ohm to infinity resistance. The previously proposed ATPG systems for this problem dealt
Tsuyoshi Shinogi +4 more
openaire +1 more source
Testing for Intermittent Resistive Faults in CMOS Integrated Systems
2016 Euromicro Conference on Digital System Design (DSD), 2016The required dependability of integrated CMOS systems has to be continuously increased because nowadays many applications are safety-critical. Having a good knowledge of potential realistic faults plays an important role in this case. The most difficult and expensive category of faults that can occur are the no-faults found (NFF).
Ebrahimi, Hassan, Kerkhoff, Hans G.
openaire +2 more sources
Antibiotic resistance in the patient with cancer: Escalating challenges and paths forward
Ca-A Cancer Journal for Clinicians, 2021Amila Nanayakkara, David Greenberg
exaly
Fault Detection in DC Microgrid Based on the Resistance Estimation
IEEE Systems Journal, 2022Premalata Jena, Kesava Rao
exaly
High Fault-Resistance Tolerable Traveling Wave Protection for Multi-Terminal VSC-HVDC
IEEE Transactions on Power Delivery, 2021Tongkun Lan +2 more
exaly
Double Ground Fault Resistance
2023 Seminar on Fields, Waves, Photonics and Electro-optics: Theory and Practical Applications (FWPE), 2023openaire +1 more source