Results 41 to 50 of about 733,717 (305)
Corrosion CommunicationsThis study used laser spectroscopy testing technology and independently constructed a testing apparatus to achieve stable measurements of the adsorbed liquid film thickness on copper surfaces. The apparatus measurement accuracy reached 91.7%.
Rongdie Zhu +4 more
doaj +1 more source
Selective Growth of Homo-Epitaxial Ag-Nano-Layer on Tribo-Assisted-Reorientation
Tribology Online, 2008 The growth process and orientational degree of incremental-Ag films with a thickness of 5, 50 and 500 nm, respectively, on reoriented Ag (111) surface were studied by in-situ reflection high-energy electron diffraction (RHEED).
Minoru Goto +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Confinement induced instability of thin elastic film [PDF]
, 2005 A confined incompressible elastic film does not deform uniformly when subjected to adhesive interfacial stresses but with undulations which have a characteristic wavelength scaling linearly with the thickness of the film.
A. Ghatak +3 more
core +1 more source
Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies
Advanced Engineering Materials, EarlyView.Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo +3 more
wiley +1 more source
An attempt to estimate liquid film thickness adhered on wall surface using ultrasonic method
Nihon Kikai Gakkai ronbunshuIn order to estimate the thickness of adhered thin liquid film on lubricating surface using ultrasonic method, a synthetic wave of reflected waves at the solid-liquid interface and multiple reflected waves in the thin liquid film was calculated and the ...
Sosho INAGAKI +2 more
doaj +1 more source
Effect of Thickness on the Structural Properties of Tellurium Film Prepared by Thermal Evaporation [PDF]
Journal of Nanostructures, 2013 In this research, tellurium (Te) film with thicknesses of 100-250 nm were deposited on ceramic substrates by thermal evaporation at 373 K. The thickness of the film was determined by Rutherford backscattering spectroscopy.
M. Manouchehrian +2 more
doaj +1 more source
Study on Tribological Characteristics of Textured Surface under Convergent Oil Film Gap
Lubricants, 2022 Under the condition of convergence, a textured non-parallel 2D slider bearing model was established, and the tribological properties of textured surface under the convergence gap were numerically studied with the load-carrying capacity as an indicator ...
Guangyao Bei +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Tc=21K in epitaxial FeSe0.5Te0.5 thin films with biaxial compressive strain
, 2009 High purity epitaxial FeSe0.5Te0.5 thin films with different thickness were grown by Pulsed Laser Ablation on different substrates. By varying the film thickness, Tc up to 21K were observed, significantly larger than the bulk value.
Bellingeri, E. +9 more
core +1 more source