Results 61 to 70 of about 1,997 (175)
Effect of impulse polarity on the flashover voltage of polluted cap and pin insulators [PDF]
, 2009 The lightning impulse flashover voltage on clean and polluted cap and pin insulators under high humidity conditions were measured. It was shown that the negative flashover voltage of non-uniformly polluted insulators is about 15% lower than the positive ...
Schwarz, H, Haeusler, H, Chrzan, K L
core
, 2009 With the aim of studying the characteristics of laser-triggered surface flashover in voltage pulse, synchronization problem of laser pulse and voltage pulse should be solved.
Zhang, D. +5 more
core +1 more source
, 1990 The development of high-voltage semiconductor devices has been hampered by the occurrence of flashover at the surface of the semiconductor. The physical mechanisms responsible for this phenomenon are not understood.
Williams, P. F. +7 more
core
Evaluation of Flashover Voltage on Hydrophobic Polymer Insulators with Artificial Neural Network
, 2012 This paper presents an experimental measurement of ac 50 Hz flashover voltage (kV) of hydrophobic polymer insulators. Hundred thirty five different testing conditions were used to evaluate the electrical performance of hydrophobic surfaces of composite ...
Aly, Saleh, Nasrat, L. S.
core
, 2018 Composite insulators are widely used in modern power systems to provide electrical insulation and mechanical support for transmission lines and substations.
Pengkang Xie +4 more
core +1 more source
Anode-Initiated Surface Flashover [PDF]
, 1979 Either of two distinctively different surface flashover mechanisms may lead to the electrical breakdown of an insulator under high voltage stress in vacuum.
Anderson, R. A.
core
Flashover Characteristics on the Gap of Rod to Plane Applied Bipolar Impulse Voltage [PDF]
, 1986 This paper describes the fifty percent flashover voltage and the V-t curve for a rod-plane gap applied bipolar impulse voltage, and the behaviour of the space charge in the gap.
MIYASATO, Kenji +2 more
core
, 1973 In order to analyze critical flashover voltage methods a set of experimentally determined data has been used. This data was supplied by the A. B. Chance Company. The data presents the flashover probability as regards to impulse voltage.
Singh, Gurdip
core
The Failure of Voltage Divider Induced by Insulating Material Degradation Under Coupling Effect of High-Frequency Field and Temperature. [PDF]
Materials (Basel)Li X +7 more
europepmc +1 more source
Pollution Flashover Characteristics of Hydrophilic/Hydrophobic Alternating Surfaces for Insulator Hybridization. [PDF]
Polymers (Basel)Tao B, Cheng L, Gong Y, Bao H, Liao R.
europepmc +1 more source