Results 241 to 250 of about 2,936,466 (288)
Storage stability of hospital-prepared mianserin suppositories: evaluation of residual active ingredient content and bacteriological contamination under different storage conditions. [PDF]
J Pharm Health Care SciTanaka R, Ichikawa T, Sato J.
europepmc +1 more source
Multi-Scale Modeling in Forming Limits Analysis of SUS430/Al1050/TA1 Laminates: Integrating Crystal Plasticity Finite Element with M-K Theory. [PDF]
Materials (Basel)Li X, Liu C, Bai Y.
europepmc +1 more source
Homo-/Heterodimeric Substrates Bias the Type and Multiplicity of Hydroxamic Acid Chelators Assembled by a NIS Synthetase DesD. [PDF]
ChemistryRosser CA, Markham TE, Codd R.
europepmc +1 more source
Determining a probabilistic forming limit curve
AIP Conference Proceedings, 2013 Forming Limit Curves are surrounded by uncertainty - in particular the uncertainty surrounding the calculation of limit strains from experimental data. The position dependent method outlined in ISO12004-2 is known to make assumptions regarding the behavior of sheet metal at the onset of necking.
N. Small +6 more
openaire +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
SpringerBriefs in Applied Sciences and Technology, 2011
In a deforming sheet, the strain state is defined as the ratio between minor strain and major strain. The formability depends on this strain state and can be expressed as the so-called forming limit curve (FLC). In complex strain states the deformation is limited by an instability just as in a tensile test. In cases of negative minor strain this can be
Wilko C Emmens
exaly +2 more sources
In a deforming sheet, the strain state is defined as the ratio between minor strain and major strain. The formability depends on this strain state and can be expressed as the so-called forming limit curve (FLC). In complex strain states the deformation is limited by an instability just as in a tensile test. In cases of negative minor strain this can be
Wilko C Emmens
exaly +2 more sources
Identification of forming limit curve at fracture in incremental sheet forming
International Journal of Advanced Manufacturing Technology, 2017Computer-aided manufacturing technology is widely used in the sheet-forming industry to predict forming performance. Strain-based forming limit criterion is popularly used for this purpose. In incremental sheet forming, the forming limit curve at fracture (FLCF) is a line from the equi-biaxial strain-point to plane strain-point and is high in ...
Young-Suk KIM
exaly +2 more sources
Calculation of the forming limit curve at fracture
Journal of Materials Science, 1983 The prediction of the forming limit diagram at fracture (FLDF) is of great importance, specially in cases where forming is controlled by fracture instead of necking. A physical model of coalescence is proposed in two cases of internal damage: (i) damage by decohesion of the particle matrix interface, and (ii) damage by failure of the particle.
J.M. Jalinier
openaire +2 more sources