Results 91 to 100 of about 74,320 (357)
EnergiesTo address the problems of the reduced evaporation rate and increased ignition time of kerosene droplets at sub-atmospheric pressures and high temperatures, boron and ethanol/water were selected as additives to be blended with RP-3 kerosene, respectively.
Jie Huang +8 more
doaj +1 more source
MATEC Web of Conferences, 2015 The features of heat and ignition of composite liquid fuel droplets in a heated (temperatures were 600–900 K) oxidant were investigated to develop modern recycling technologies of processing waste of coal, petroleum products, liquid fuels and combustible
Kosintsev A. G. +2 more
doaj +1 more source
The risk of explosion during the transport and storage of liquid fuels [PDF]
MATEC Web of ConferencesWhen transporting and storing liquid fuels, explosive atmospheres can form which, under certain conditions, can be initiated with different sources, of which static electricity has proven to be the source of ignition in many cases of fires and explosions
Paraian Mihaela, Radu Ancuta Mirela
doaj +1 more source
Influence of diesel surrogates on the behavior of simplified spray models [PDF]
, 2012 Numerous experimental investigations make use of diesel surrogates to make the computational time reasonable. In the few studies where measured (surrogate and real diesel) and computed (surrogate only) results have been compared, the selection ...
F Battin-Leclerc +6 more
core +2 more sources
Ultra‐High Nickel Oxides as Cathode Materials for High‐Energy Lithium‐Ion Batteries
ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.Ultra‐high nickel layered oxides are among the most promising cathode materials for high‐energy lithium‐ion batteries, offering high specific capacity and significant utilization in both conventional lithium‐ion batteries and solid‐state batteries. This review article introduces the basic structure of ultra‐high nickel layered oxides, then delves into ...
Yilong Han +6 more
wiley +1 more source
Preliminary Tests on the Vaporization of Fuel Sprays [PDF]
High-speed motion pictures were taken of fuel sprays injected into the combustion chamber of the N.A.C.A. combustion apparatus. Three fuels, ethyl alcohol, gasoline, and fuel oil, which differed considerably in volatility were tested.
Rothrock, A M
core +1 more source
A Comparison of Sensitivity Metrics for Two-Stage Ignition Behavior in Rapid Compression Machines [PDF]
, 2017 A rapid compression machine (RCM) multi-zone model is used to simulate the ignition of primary reference fuel (PRF) mixtures that exhibit two-stage ignition behavior.
Allen, Casey, Wilson, David
core +1 more source
Ignition length study of jp-8 + 100 in a supersonic duct [PDF]
, 2016 In scramjets, hydrocarbon fuels are being considered for their endothermic potential and for use in flights where compact, volume critical designs are required at flight speeds at Mach 5+. Long-chain hydrocarbon (LCHC) fuels, like aviation kerosene, have
Bateup, M. L.
core +1 more source
ENERGY &ENVIRONMENTAL MATERIALS, EarlyView.Flame‐retardant bio‐based thermo‐flexible phase‐change composites for advanced battery thermal management. Batteries face critical challenges in thermal management, including overheating risks, poor interfacial contact, and mechanical vibration–induced performance attenuation.
Shichao Feng +7 more
wiley +1 more source
The effect of aging time on mechanical and microstructure properties of aa6061 joints welded by gas tungsten arc welding [PDF]
, 2018 This research examines the influence of heat treatment on mechanical properties and microstructure of AA6061 aluminium alloy welded with butt groove method, by using Gas Tungsten Arc Welding (GTAW) method.
Ahmad, R
core