Results 61 to 70 of about 74,413 (318)
METHOD OF CONVERSION OF HIGH- AND MIDDLE-SPEED DIESEL ENGINES INTO GAS DIESEL ENGINES
Facta Universitatis. Series: Mechanical Engineering, 2017 The paper aims at the development of fuel supply and electronic control systems for boosted high- and middle-speed transport engines. A detailed analysis of different ways of converting diesel engine to operate on natural gas was carried out.
Mikhail G. Shatrov +4 more
doaj +1 more source
THE GAS ENGINEER'S LABORATORY HANDBOOK. [PDF]
Journal of the American Chemical Society, 1902 n ...
openaire +1 more source
Gas Turbine Engine Performance Deterioration Modelling and Analysis [PDF]
, 1988 In-service performance deterioration of gas turbine engines can be identified, at the engine module level, in terms of reductions in the component mass flow and the efficiency. Continued operation of a deteriorated gas turbine is (i) uneconomical and
Singh Grewal, M.
core
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Influence and Quantitative Analysis of Different Parameters on Adaptive Cycle Fan Performance
AerospaceThis study investigates the adaptive cycle fan (ACF), a key component enabling variable-cycle functionality in next-generation adaptive cycle engines (ACE).
Heli Yang +4 more
doaj +1 more source
Internal Combustion Engine Powered by Synthesis Gas from Pyrolysed Plastics
Journal of Mechanical Engineering, 2016 The article discusses the application of synthesis gas from pyrolysis of plastics in petrol engine. The appropriate experimental measurements were performed on a combustion engine LGW 702 designated for micro-cogeneration unit.
Chríbik Andrej +5 more
doaj +1 more source
Multi-disciplinary conceptual design of future jet engine systems [PDF]
, 2010 This thesis describes various aspects of the development of a multi-disciplinary aero engine conceptual design tool, TERA2020 (Techno-economic, Environmental and Risk Assessment for 2020), based on an explicit algorithm that considers: engine ...
Kyprianidis, Konstantinos G.
core
Laser Powder Bed Fusion of Alumina: Effects of Scanning Strategies on External and Internal Defects
Advanced Engineering Materials, EarlyView.This study investigates how scanning strategies affect pure alumina in laser powder bed fusion. Linear 45° scanning yields uniform surfaces but high porosity, while the island‐concentric strategy provides higher density with through‐holes favorable for infiltration. Findings highlight pathways toward optimizing defect‐free alumina parts.
Mohamed Abdelmoula +7 more
wiley +1 more source
Improvement and validation of a thermodynamic S.I. engine simulation code [PDF]
, 2003 This study was concerned with improvement and validation of a thermodynamic spark ignition engine simulation code developed in Leeds. Experimental validation data were generated using a central ignition, disc-shaped combustion chamber variant of a ...
Abdi Aghdam, Ebrahim
core
Advanced Engineering Materials, EarlyView.This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source