Results 121 to 130 of about 2,088,473 (297)
Advanced Engineering Materials, EarlyView.Reproduction of stacking fault energy calculations from literature with a semi‐automated large language model‐assisted extraction procedure: extraction of simulation protocol, atomistic structures, computational parameters, and reported results, ontology alignment, knowledge graph construction and, finally, recomputation forvalidation.
Sepideh Baghaee Ravari +5 more
wiley +1 more source
FAILURE ANALYSIS OF HIGH STRENGTH ALUMINUM ALLOY WHEEL
Jixie qiangdu, 2018 The mechanism of cracks initiation and propagation of high strength aluminum alloy rims for heavy vehicles were analyzed. Tensile testing machine,optical microscopy,scanning electronic microscope and energy disperse spectrometer detailed characterization
YU JianMin, ZHANG ZhiMin, WANG Qiang
doaj
THE INITIAL CREEP OF COLUMNAR-GRAINED ICE: PART II. ANALYSIS
Canadian Journal of Physics, 1965 Observations on the initial creep behavior of columnar-grained ice are analyzed by assuming that the creep strain at a given time has a power-law dependence on the applied constant compressive stress. The exponent for the stress was time-dependent during transient creep.
openaire +3 more sources
In Situ Micromechanical Study of Bimodal γ′–γ″ Precipitate Assemblies in Ni–Cr–Al–Nb Superalloy
Advanced Engineering Materials, EarlyView.A Ni–Cr–Al–Nb superalloy with a bimodal γ′–γ″ precipitate distribution is developed. Composite precipitate assemblies form through heterogeneous nucleation, effectively impeding dislocation motion. Micropillar compression reveals high strength at room and elevated temperatures, governed by precipitate shearing, with coupled faulting mechanisms ...
Ujjval Bansal +4 more
wiley +1 more source
Turbulence Intermittency Effects on the Initiation Threshold of Sediment Motion in Natural Waters
Water Resources ResearchThe initiation threshold of sediment motion, a key component in quantifying sediment transport, has potential link to intermittent turbulence bursts. Here, we elaborated in situ experiments on coastal sea bottom covered with cohesive sediments, to obtain
Renzhi Li, Ya Ping Wang, Shu Gao
doaj +1 more source
Advanced Engineering Materials, EarlyView.Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
Journal of Materials Research and TechnologyThe grain characteristic and orientation were analyzed using the electron backscatter diffraction (EBSD) for AZ31 hot-rolled alloys. The corrosion initiation of the bimodal microstructure is revealed for the hot-rolled AZ31 alloys obtained by the quasi ...
Chunde Zhou +6 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Coarse‐grained (left) and atomistic (right) models of the shape memory polymer ESTANE ETE 75DT3 are shown schematically. The two representations bridge molecular detail and mesoscopic description. Both models capture shape memory behavior, linking segmental mobility and conformational relaxation of anisotropic chains to macroscopic recovery, and ...
Fathollah Varnik
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study shows that superalloys used in aircraft engine disks become much more prone to deformation at high temperatures if they have been strained during manufacturing. This effect increases with the level of prior strain but eventually reaches a limit.
Fabio Machado Alves da Fonseca +9 more
wiley +1 more source