Results 221 to 230 of about 2,695 (261)
Some of the next articles are maybe not open access.

Mutual Impedances of Grounded Circuits

Bell System Technical Journal, 1922
Formulas are derived for the direct-current mutual resistance and inductance between circuits grounded at the surface of the earth. For circuits composed of straight filaments, the mutual inductance is reduced to known Neumann integrals which involve only comparatively simple expressions for the case of horizontal, coplanar conductors above, below or ...
openaire   +1 more source

Mutual impedance of grounded wires

Electrical Engineering, 1931
A formula is given for the mutual impedance between two insulated wires of negligible diameter lying on the surface of the earth and grounded at their end-points.
openaire   +1 more source

Fundamental Considerations and Impluse Impedance of Grounding Grids

IEEE Transactions on Power Apparatus and Systems, 1981
The impulse impedance of a grounding grid must be known for determining its performance while discharging impulse currents to ground if problems concerning lightning protection and transients under ground faults are to be accurately analysed. This paper out-lines the basic concepts required for this study, analyses the equivalent circuit ,21]of a ...
R. Verma, D. Mukhedkar
openaire   +1 more source

High Frequency Characteristics of Impedances to Ground And Field Distributions of Ground Electrodes

IEEE Transactions on Power Apparatus and Systems, 1981
High frequency characteristics of impedances to ground and field distributions of ground electrodes are calculated by the current simulation method together with the method of images. Numerical calculations concerning some typical electrodes are shown.
T. Takashima, T. Nakae, R. Ishibashi
openaire   +1 more source

On the evaluation of input impedance and transient impedance for grounding electrodes using antenna theory

COMPEL: The International Journal for Computation and Mathematics in Electrical and Electronic Engineering, 2013
Purpose – The purpose of this paper is to propose a fast, accurate and efficient algorithm for assessment of input impedance and consequently the evaluation of transient impedance of the grounding electrode. Design/methodology/approach – The mathematical model is ...
Poljak, Dragan, Čavka, Damir
openaire   +1 more source

Evaluation of the Accuracy of Grounding Impedance Measurement of Grounding Grid

Journal of the Korean Institute of Illuminating and Electrical Installation Engineers, 2009
Recently, the common grounding systems are adapted in most large structures. Since the ground resistance is insufficient to evaluate the performance of grounding systems, it is needed to measure grounding impedance. Even though the methods of measuring grounding impedance of large grounding systems are presented in IEEE standard 81.2, but they have not
openaire   +1 more source

NOTE ON THE IMPEDANCE OF A GROUNDED WIRE

Geophysical Prospecting, 1960
AbstractThe self‐inductance of a straight grounded wire lying on the surface of the earth is computed from a (slightly corrected) formula given by A. Wolf and compared to approximate formulae.
openaire   +1 more source

Experimental Study of Transient Ground Impedances

IEEE Power Engineering Review, 1981
This paper presents the results of an experimental investigation of the transient behavior of ground impedances. The results obtained were used to derive equivalent circuits. An analog model was constructed and satisfactory agreement with the theoretical analysis obtained.
R. Kosztaluk, M. Loboda, D. Mukhedkar
openaire   +1 more source

Transient impedance of GIS grounding grid

IEEE Transactions on Power Delivery, 1995
The transient impedance of a grounding grid for a commercial 550 kV gas-insulated substation (GIS) was measured on site using steep front currents with rise time from 100 ns to 2 /spl mu/s. From the measured results, it was found that the transient impedance of the measured grid for those currents is simulated by a series circuit with an inductance 1 ...
S. Karaki   +6 more
openaire   +1 more source

Aspects of direct deduction of ground impedance

The Journal of the Acoustical Society of America, 2007
ANSI S1.18 1998 offers a method for determining ground impedance by fitting data to templates of the magnitude of level difference obtained using a point source and two vertically separated microphones with specified geometries according the ‘‘acoustical-softness’’ of the ground.
Keith Attenborough   +3 more
openaire   +1 more source

Home - About - Disclaimer - Privacy