Results 51 to 60 of about 263,380 (266)

Understanding the Stochastic Nature of Process Parameter Development of Blown Powder Laser Beam Directed Energy Deposition Additive Manufacturing of Pure Molybdenum

Advanced Engineering Materials, EarlyView.
Identified through the use of statistical design of experiments and metallographic investigation, this study exposes the stochastic origins of intergranular cracks in blown powder laser beam directed energy deposition additive manufacturing of pure molybdenum. It further demonstrates a successful crack mitigation approach with direct correlation to the
Nathaniel J. Lies, Daniel E. Driemeyer, Aaron P. Stebner   +2 more
wiley   +1 more source

Design of a magnetic encoder using Hall effect

Visión Electrónica, 2019
We present the design of a magnetic encoder to measure angular position. The proposed encoder includes two Hall sensors in quadrature in a fixed platform. In addition, and over the sensors, there are two permanent magnets in a shaft.
William Alejandro López-Contreras, José Danilo Rairán-Antolines   +1 more
doaj   +1 more source

Quantum Hall effects

, 2011
These lecture notes yield an introduction to quantum Hall effects both for non-relativistic electrons in conventional 2D electron gases (such as in semiconductor heterostructures) and relativistic electrons in graphene. After a brief historical overview in chapter 1, we discuss in detail the kinetic-energy quantisation of non-relativistic and the ...
openaire   +2 more sources

Microstructure Evolution of a VMnFeCoNi High‐Entropy Alloy After Synthesis, Swaging, and Annealing

Advanced Engineering Materials, EarlyView.
The synthesis and processing (rotary swaging and annealing) of the novel VMnFeCoNi alloy is investigated, alongside the estimation of the grain size effect on hardness. Analysis of a wide grain size range of recrystallized microstructures (12–210 µm) reveals a low annealing twin density.
Aditya Srinivasan Tirunilai, Zeki Ayrildi, Buse Şen, Maik Rajkowski, Mathias Redondo Garcia, Markus Stricker, Guillaume Laplanche   +6 more
wiley   +1 more source

Anomalous Hall effect in single-band chiral superconductors from impurity superlattices

Physical Review Research, 2020
Unlike anomalous quantum Hall insulators, clean single-band chiral superconductors do not exhibit intrinsic Hall effect at the one-loop approximation.
Yu Li, Zhiqiang Wang, Wen Huang
doaj   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source

Signature of topological Hall effect in layered FePd2Te2 ferromagnet

Materials Futures
Van der Waals (vdW) magnetic materials offer a flexible platform for exploring low-dimensional spin-dependent transport. FePd _2 Te _2 (FPT) is a layered ferromagnet with a Curie temperature of ∼185 K, whose magnetic anisotropy and domain structure give ...
Jinjin Liu, Zherui Yang, Liu Yang, Baowen Li, Yanran Liu, Zhiwei Wang, Qiong Wu, Dongchen Qi, Xiao Renshaw Wang   +8 more
doaj   +1 more source

Influence of Scan Strategies in Electron Beam Powder Bed Fusion on Solidification, Microstructure, and High‐Temperature Compressive Properties of γ′‐Strengthened Inconel 738LC

Advanced Engineering Materials, EarlyView.
Experiments and thermophysical simulations were conducted to investigate the electron beam powder bed fusion electron beam (PBF‐EB/M) process for the γ′‐strengthened nickel‐based superalloy Inconel 738LC. The results demonstrate the impact of process‐induced microstructural variations on high‐temperature mechanical behavior, providing a basis for ...
Jan Niklas Petenati, Karthik Kumar Banku, Prasanth Bondi, Ivan Zhirnov, Yangyiwei Yang, Gordon Schmidt, Jürgen Christen, Georg Hasemann, Manja Krüger, Bai‐Xiang Xu, Bilal Gökce, Silja‐Katharina Rittinghaus   +11 more
wiley   +1 more source

Photon Thermal Hall Effect [PDF]

Physical Review Letters, 2016
A near-field thermal Hall effect (i.e.Righi-Leduc effect) in networks of magneto-optical particles placed in a constant magnetic field is predicted. This many-body effect is related to a symmetry breaking in the system induced by the magnetic field which gives rise to preferential channels for the heat-transport by near-field interaction thanks to the ...
openaire   +4 more sources

Impact of MgO Additions on the Oxidation Resistance and Compression Behavior of Vanadium Alloys

Advanced Engineering Materials, EarlyView.
An increase in oxidation resistance at 600 °C is achieved for alloys containing more than 2.5 wt.% MgO. It has been established that, along with V2O5, MgO6V2, and Mg2O7V2 are formed, which are presumed to enhance oxidative stability. Furthermore, the possible transformation of Mg‐vanadates through reaction with CO2, which presumably occurs in this ...
Ievgen Solodkyi, Mathias Galetz, Georg Hasemann, Fabian Lanoy, Emma White, Manja Krüger   +5 more
wiley   +1 more source