Results 1 to 10 of about 1,935,322 (253)
Head-Positioning Control Using Virtual Resonant Modes in a Hard Disk Drive
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2007 In conventional control systems in hard disk drives, it is difficult to compensate for disturbances above the primary mechanical resonance. In this paper, a design method that uses a virtual resonant mode in head-positioning systems of hard disk drives ...
Takenori ATSUMI
doaj +3 more sources
Temperature phase transitions in Rb2KRe3+F6 elpasolites - Raman spectroscopy study
Materials and Devices, 2021 Phase transitions in crystals of fluorine-containing elpasolites are investigated by Raman scattering spectroscopy. It was found that lattice instabilities in these crystals are induced by soft mode condensations, while restorations of these modes in ...
Alexander N VTYURIN +5 more
doaj +6 more sources
Customization of two-dimensional extremal materials
Materials & Design, 2022 Extremal materials are elastic metamaterials with rank-deficient elasticity tensor. Due to this novel property of the elasticity tensor, extremal materials (especially pentamode materials) show outstanding performance in various wave manipulation ...
Ming Cai +3 more
doaj +1 more source
Vibrations of straight pipes/beams with two-sided stops: Analytical and numerical analyzes
Forces in Mechanics, 2021 The impacts on pipes or beams are of fundamental mechanical interest. These impacts can be studied analytically. This makes it easier to examine the basic effects and to compare these effects with the results of finite element analyzes (FEA).
H. Schau, T. Hermann, W. Hienstorfer
doaj +1 more source
MODULATIONAL INSTABILITY OF THE RADIAL VIBRATIONS OF CORONAL LOOPS
Современная наука и инновации, 2022 Axisymmetric modes in coronal loops are used to interpret observed fast microwave and hard x-ray pulsations. Their properties are well studied in the approximation of linear magnetic hydrodynamics.
Galina Alekseevna Mankaeva +3 more
doaj +1 more source
Influence of the parameters of magnetic abrasive treatment on the surface roughness of carbide tools [PDF]
Металознавство та обробка металів, 2019 Considered the influence of the modes of magnetic-abrasive treatment using a ball magnetic-abrasive tool on the roughness of the working surfaces of the multifaceted non-retractable hard-alloy plates.
Bobyn A.B. +2 more
doaj +1 more source
Research on the typical fault modes of multi-category aviation transformer rectifier units
Hangkong gongcheng jinzhan, 2023 With the development of multi-electric aircraft, the researches on the structure improvement and fault di-agnosis of aviation transformer rectifier units (TRUs) are increasing, but research on the characteristics and effects of typical fault modes of ...
CHEN Shuwen, YU Nalun
doaj +1 more source
Journal of Oral and Maxillofacial Radiology, 2019 Background: Cone-beam computed tomography (CBCT) has gained considerable use, while radiation burden remains an important concern. Aims: This study aimed at determining the entrance skin dose of the thyroid gland area through exposure with the normal ...
Bardia Vadiati Saberi +5 more
doaj +1 more source
Delocalized nonlinear vibrational modes and their effect on the properties of binary NiTi alloy [PDF]
Известия высших учебных заведений: Прикладная нелинейная динамикаThe purpose of this work is to investigate the behavior of stable one-component delocalized nonlinear vibrational modes in simple cubic titanium and nickel sublattices, as well as their influence on the properties of the binary NiTi alloy. Methods.
Bachurin , Dmitry Vladimirovich +1 more
doaj +1 more source
Journal of Low Frequency Noise, Vibration and Active Control, 2021 Blade crack will cause severe mistuning of hard-coated blisks, which will lead to vibration localization. To identify crack mistuning and analyze influence factors, in this study, a mistuning identification method of blade cracks in hard-coated blisks is
Kunpeng Xu +3 more
doaj +1 more source