Low heat flow from young oceanic lithosphere at the Middle America Trench off Mexico
, 2005 Seismic reflection profiles across the Middle America Trench at 20°N show a high amplitude bottom simulating reflector interpreted as marking a phase transition between methane hydrate and free gas in the pore space of both accreted and trench sediments.
Bartolome, R. +7 more
core +1 more source
Parametric and heat affected zone study on CO2 laser cutting of acrylic. [PDF]
MethodsX, 2023 Palanisamy C, Efzan M, Wen CC.
europepmc +1 more source
Enhanced Strength and Corrosion Resistance of Ti‐13Nb‐12Ta‐10Zr‐4Sn Alloy by Aging Treatment
Advanced Engineering Materials, EarlyView.This work systematically investigates the effect of aging treatment on mechanical properties and corrosion behavior of vacuum arc‐melted Ti‐13Nb‐12Ta‐10Zr‐4Sn alloy. Owing to the increased α″ martensite, strength and corrosion resistance were significantly enhanced by aging treatment.
Yuhua Li +5 more
wiley +1 more source
Heat Rejection in Condensers: Desuperheating, Condensation in Superheated Region and Two Phase Zone
, 2012 Conventional modeling of condensers always assumes three zones: desuperheating, condensation and subcooling even condensation occurs in desuperheating zone at some conditions and that subcooling occurs during condensation. This paper discusses the actual
Hrnjak, Predrag S., Kondo, Chieko
core
Advanced Engineering Materials, EarlyView.Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir +5 more
wiley +1 more source
Effect of Heat Input on Microstructure and Properties in Heat Affected Zone of ASTM A572 GR.65 Steel
, 2010 The correlation among heat input (HI), microstructure and properties in heat affected zone of ASTM A572 GR.65 steel (GR.65 steel) was investigated using optical microscopy (OM), Vickers hardness tester and Charpy-V-Notch (CVN) testing.
Yin Ye +4 more
core +1 more source
Characterization of Microstructural Evolution in Heat-Affected Zone of Cu-Bearing Ultra-High-Strength Steel with Lamellar Microstructure. [PDF]
Materials (Basel), 2023 Fang C, Li C, Ji F, Fu W, Hu W, Di X.
europepmc +1 more source
Nondestructive Testing of Welded Composite Metal Foams
Advanced Engineering Materials, EarlyView.X‐ray computed tomography (CT) is used to evaluate welded steel–steel composite metal foam (CMF) joints of two density classes. It reports variation in postweld spatial void distribution and correlates it to weld‐induced changes, mechanical performance, and failure within welded CMF panels.
Chinmaya Prerana Inguva +2 more
wiley +1 more source
Effect of cutting speed by laser on Thickness of heat affected zone of mild steel S235
, 2014 The presented article describes the technology of laser cutting. Article describes the characteristics of the laser beam by CO2 laser, the factors on the process of laser cutting, assistance gas and interaction cut material properties and stability of ...
Nigovič, Rastislav +2 more
core
Simulation and Mechanical Properties of Fine-Grained Heat-Affected Zone Microstructure in 18CrNiMo7-6 Steel. [PDF]
Materials (Basel), 2022 Vuherer T +4 more
europepmc +1 more source