Results 271 to 280 of about 17,833 (305)

Heat Transfer in Spiral Channel Heat Sinks

ASME 2011 9th International Conference on Nanochannels, Microchannels, and Minichannels, Volume 1, 2011
Heat transfer in a spiral heat sink is examined experimentally and analytically. The spiral channel was fabricated on a base plate of copper. The cross section of the channel is square with 1 mm sides. A copper cap plate was bolted tight to seal the channel.
M. Ghobadi, Y. S. Muzychka
openaire   +1 more source

Partially heated heat sinks in a zero-bypass

International Communications in Heat and Mass Transfer, 2012
Abstract The need to improve the thermal performance of heat sinks remains a design priority for thermal engineers. Most of the considerations so far have involved various shapes and sizes of the fin designs. This numerical study evaluates the influence of the heating position on the thermal performance of a plate-fin heat sink in a zero-bypass ...
N.G. Emekwuru, F.R. Hall, P.J. Spence
openaire   +1 more source

Measurements of heat transfer in microchannel heat sinks

International Communications in Heat and Mass Transfer, 2000
Abstract The paper presents new experimental measurements for pressure drop and heat transfer coefficient in microchannel heat sinks. Tests were performed with devices fabricated using standard Silicon 100 wafers. Two different channel patterns were studied.
openaire   +1 more source

Thermal management and temperature uniformity enhancement of electronic devices by micro heat sinks: A review

Energy, 2021
Ziqiang He, Yunfei Yan, Zhien Zhang
exaly  

Fluid flow and heat transfer characteristics of microchannel heat sinks with different groove shapes

International Journal of Thermal Sciences, 2021
Qifeng Zhu
exaly  

Heat sink design: heat sink design for a company.

Throughout the project, I utilized SolidWorks Software to design, assemble, and simulate a heat sink for a heat sink company with a computer science background that needs it to be used on a silicon computer chip. The primary objective was to design a heat sink that could lower the temperature of the silicon chip to less than 43.5ºC.
openaire   +1 more source

Effects of pin fin height, spacing and orientation to natural convection heat transfer for inline pin fin and plate heat sinks by experimental investigation

International Journal of Heat and Mass Transfer, 2021
Eyüb Canli
exaly  

Epicardial Cryoablation and the Heat-Sink Problem

The Annals of Thoracic Surgery, 2022
openaire   +2 more sources

Heat transfer and pressure drop characteristics of R134a flow boiling in the parallel/tandem microchannel heat sinks

Energy Conversion and Management, 2017
Zhichun Liu
exaly  

When Is a Heat Sink Not a Heat Sink?

1998
openaire   +1 more source