Results 31 to 40 of about 16,083,913 (302)
Vibration Identification of Folded-MEMS Comb Drive Resonators
Micromachines, 2018 Natural frequency and frequency response are two important indicators for the performances of resonant microelectromechanical systems (MEMS) devices.
Jianxin Han +6 more
doaj +1 more source
High Speed Blanking: An Experimental Method to Measure Induced Cutting Forces [PDF]
, 2013 Lien vers la version éditeur: http://link.springer.com/article/10.1007/s11340-013-9738-1A new blanking process that involves punch speed up to 10 ms −1 has obvious advantages in increased productivity.
LARUE, Arnaud +5 more
core +1 more source
Measurement of the Euler Angles of Wurtzitic ZnO by Raman Spectroscopy
Journal of Spectroscopy, 2017 A Raman spectroscopy-based step-by-step measuring method of Euler angles φ,θ,and ψ was presented for the wurtzitic crystal orientation on a microscopic scale.
Wu Liu, Qiu Li, Gang Jin, Wei Qiu
doaj +1 more source
Micromachines, 2018 This paper attempts to qualitatively identify the static pull-in position, pull-in voltage, and fundamental frequency of one-electrode microresonators from a physical perspective. During theoretical derivation, a generalized one-degree-of-freedom (1-DOF)
Jianxin Han +6 more
doaj +1 more source
Design of an active dynamic balancing head for rotor and its balancing error analysis
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2015 The unbalancing vibration monitoring and control of rotating machinery is an important engineering problem. In order to correct the unbalance of rotor system online, an active dynamic balancing head is designed based on the ratchet-pawl mechanism and ...
Zhang SHIHAI, Zhang ZIMIAO
doaj +1 more source
The Effect Analysis of Carrier Gas Flow Rate on the Rapid Gas Chromatographic Separation System
Applied Bionics and Biomechanics, 2020 Odor pollution did not only disturb the human normal life but also aroused the attention of environmental researchers and environmental protection departments.
Xu Zhang +3 more
doaj +1 more source
Research on Roughness and Microhardness of C45 Material Using High-Speed Machining
Applied Sciences, 2023 From the point of view of production, it is of fundamental importance to know the cutting parameters at which the new surface of the component was created because only in this way is it possible to understand the nature and properties of the created ...
Jan Duplak +2 more
doaj +1 more source
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2016 Torsional stiffness of a rotary feed drive system not only has great influence on the rotary positioning accuracy, but also affects the system dynamic characteristics.
Lin HAN, Fujun WANG
doaj +1 more source
Metals, 2023 This research investigates the impact of high-speed and thermal-assisted machining (HS-TAM) on tool wear and surface roughness during the milling of SKD11 steel. The goal is to identify high-speed and elevated temperature zones that can improve machining
Thi-Bich Mac +2 more
doaj +1 more source
Onset and evolution of discontinuously segmented chip flow in ultra-high-speed cutting Ti-6Al-4V [PDF]
, 2017 Increasing the cutting speed to an ultra-high level usually gives rise to a chip flow transition from continuously serrated to discontinuously segmented, which is one of the most fundamental and challenging problems in metal cutting.
Ye GG +4 more
core +1 more source