Results 81 to 90 of about 987 (192)

A Comprehensive Review of Tire Abrasion: Mechanisms, Parameters, and Wear Rates in the Era of Vehicle Electrification

Applied Research, Volume 5, Issue 4, August 2026.
The type of vehicle (internal combustion, hybrid, electric) has a direct effect on its tire wear particle emission. As expected, electric vehicles generate higher amounts due to their higher weight and torque, but regenerative breaking must also be accounted for.
Xiao Yuan Chen, Denis Rodrigue
wiley   +1 more source

Shaking Table Tests and Numerical Analysis of Rocking Vault‐Shaped Segmental Piers Equipped With an Annular Double Sliding System

Earthquake Engineering &Structural Dynamics, Volume 55, Issue 10, Page 2233-2254, August 2026.
ABSTRACT To enhance the structural robustness of bridges, a rocking arch‐shaped segmental pier with a double sliding system was previously proposed as a low‐cost solution to protect bridges in developing countries. The rocking behavior is triggered by halting the sliding motion, which increases the horizontal load‐bearing capacity and limits ...
Shengming Feng, Mitsuyoshi Akiyama, Shintaro Kobayashi, Ryosuke Kato, Elisa Vitolo, Hirokazu Takahashi, Shun Arima   +6 more
wiley   +1 more source

FE-BE computation of electromagnetic noise of a permanent-magnetic excited synchronous ma-chine considering dynamic rotor eccentricity

MATEC Web of Conferences, 2018
Electromagnetic noise in Electrical Machines (EMs) occurs due to vibrations caused by magnetic forces acting onto rotor and stator surface. This is the dominant source for the considered permanent-magnetic excited synchronous machine in this paper.
Clappier Marcel, Gaul Lothar
doaj   +1 more source

Full‐scale Shaking Table Tests on a 10‐story Steel Moment‐resisting Frame Building with Buckling‐restrained Braces

Earthquake Engineering &Structural Dynamics, Volume 55, Issue 10, Page 2356-2378, August 2026.
ABSTRACT In February 2023, a comprehensive series of shaking table tests were conducted at the E‐Defense facility, the world's largest three‐dimensional earthquake simulator, on a full‐scale 10‐story steel moment‐resisting frame supplemented with BRBs.
Jun Fujiwara, Jialiang Jin, Jionghui Li, Tianhao Yan, Ryota Nishi, Akiko Kishida, Koichi Kajiwara, Takuya Nagae, Taichiro Okazaki, Tatsuya Asai   +9 more
wiley   +1 more source

Seismic Fragility and Vulnerability of Partially Grouted Flexural‐Controlled Reinforced Masonry Buildings in Colombia

Earthquake Spectra, Volume 42, Issue 3, August 2026.
This paper presents the development of analytical fragility and vulnerability functions for flexure‐controlled partially grouted reinforced masonry (RM) buildings that are representative of Colombian urban areas, with the goal of enhancing national seismic risk assessments.
Juan C. Reyes, J. Paul Smith‐Pardo, Santiago Portilla, Emersson Torres, Andrea C. Riaño   +4 more
wiley   +1 more source

The Hysteretic Behavior and Restoring Force Model of the K-shape Outer Sleeve RHS Joints

工程科学与技术, 2010
:Based on ADINA program, numerical analysis was applied to study the hysteretic behavior of K-type welded outer sleeve RHS joints subjected to axially cyclic load, using the nonlinear method of Newton-Raphson with Low-Speed Dynamics Damping Factor ...
Yu Zhi-Xiang, Yan Yan-Jun, Zhao Shichun
doaj  

Frequency-independent damping models for a high-rise building with simultaneous horizontal and vertical seismic motions

Frontiers in Built Environment
Recent seismic analyses indicate that the structural damping ratio should be considered frequency-independent, for safe and accurate estimations. In response, damping models like the Wilson–Penzien (WP) damping model, that is one of the modal damping ...
Naohiro Nakamura, Yoshihiro Mogi, Akira Ota, Kunihiko Nabeshima   +3 more
doaj   +1 more source

MODEL AND EXPERIMENT OF THE HYSTERIS CHARACTERISTICS ON MAGNETORHEOLOGICAL DAMPING LATHE TOOL

Jixie qiangdu, 2016
Cutting chatter is one of the major problems which constraints the high-performance and high-precision of the machining products. A damping lathe tool based on intelligent material — magnetorheological fluid was developed in order to effectively suppress
ZHANG YongLiang, GU Tao, PAN JianJian
doaj  

Discussion of Paper by Chin, Cheng, Lepage, and Lequesne

Earthquake Engineering &Structural Dynamics, Volume 55, Issue 10, Page 2223-2232, August 2026.
Prateek Shah, Santiago Pujol, Liam Pledger, Lucas Laughery   +3 more
wiley   +1 more source

AN ANALYTICAL MODEL FOR SEISMIC ISOLATION DEVICES WITH HYSTERETIC DAMPING

Journal of Structural and Construction Engineering (Transactions of AIJ), 2003
Masaru KIKUCHI, Yoshihisa KITAMURA, Keiichi INOUE, Masaiki UEDA   +3 more
openaire   +2 more sources