Results 71 to 80 of about 80,527 (240)

Self‐Sintering Ionogel Binder for Flexible, Recyclable, and Healable Printed Giant Magnetoresistive Sensors

open access: yesAdvanced Functional Materials, EarlyView.
ABSTRACT Electronic waste has emerged as a major environmental challenge, driven by the massive consumption and a limited lifetime of modern electronic devices, stimulating the development of sustainable electronics. Here, an all‐biomaterial gelatin‐choline‐citric acid ([Ch][CA]) ionogel is developed as an active binder to realize self‐sintered ...
Lin Guo   +10 more
wiley   +1 more source

Receptor‐Free Identification of Toxic Gases Enabled by Hygroscopic Aqueous Salt Films

open access: yesAdvanced Functional Materials, EarlyView.
Water as a gas sensor coating sounds impossible—until it stops evaporating. Here, hygroscopic salt solutions (LiCl, LiBr, H3PO4) form non‐drying aqueous films on CNT chemiresistors under ambient air. Gases partition into these liquid layers, sometimes transforming into water, and generate salt‐specific resistance fingerprints across a four‐channel ...
Seongwoo Lee   +5 more
wiley   +1 more source

Fast Charge–Discharge of LiNi0.9Co0.05Mn0.05 Enabled by a Bikitaite‐Infused Separator for Li Metal Batteries

open access: yesAdvanced Functional Materials, EarlyView.
A bikitaite‐infused cellulose separator is introduced for Li metal batteries, leveraging bikitaite zeolite's ion‐conductive properties to regulate Li+‐ion flux and suppress dendrite growth. The membrane design ensures uniform Li plating, enhanced electrolyte wettability, and robust thermal/mechanical stability, delivering stable performance and low ...
Isheunesu Phiri   +2 more
wiley   +1 more source

Exploring an Alternative to mRNA Vaccine Cold Chain Storage: MRNA‐Lipid Nanoparticle Stability When Dried in a Polymer Matrix

open access: yesAdvanced Functional Materials, EarlyView.
The nanostructure, size, and function of mRNA‐loaded lipid nanoparticles are evaluated before drying, within polymer microneedles, and after rehydration. The results reveal the polymer and LNP loadings required to recover nanostructure and preserve the delivery performance in dry‐state formulations.
Brendan P. Dyett   +19 more
wiley   +1 more source

In situ measurement of mechanical stress in polycrystalline zinc oxide thin films prepared by magnetron sputtering

open access: yes, 2000
The generation of stress in magnetron sputtered undoped and aluminum doped zinc oxide ZnO Al films has been measured by an in situ technique. Radio frequency magnetron sputtering from ceramic targets in an argon atmosphere was used for film deposition.
Hinze J., Ellmer K.
core   +1 more source

Transfer Printing and Reconfiguration of Soft Electronics Using Digital Microfluidics and Laser Machining

open access: yesAdvanced Functional Materials, EarlyView.
This paper presents a digital microfluidics‐based technique for transferring and reconfiguring soft nanomembranes. Laser‐machined nanothin membranes are picked up, transported, and aligned via tailored surface tension and the actuation of water droplets, enabling the development of flexible electronics, the integration of functional materials on 3D ...
Quang Anh Nguyen   +15 more
wiley   +1 more source

Orbital Geometry‐Governed Response of Pressure‐Tunable Quantum Defects in hBN

open access: yesAdvanced Functional Materials, EarlyView.
Defects in hBN act as ultrasensitive quantum manometers when the energy of the intradefect optical transitions is modified by lattice compression. The orbital geometry of the electron wave functions governs how electron hopping and Coulomb interactions react uniquely to the reduction of the van der Waals gap and in‐plane compression, leading to robust ...
Magdalena Grzeszczyk   +6 more
wiley   +1 more source

Dipole‐Engineered Conductive Additives for Ultrastable Interphase Evolution in High‐Areal‐Capacity Silicon Anodes

open access: yesAdvanced Functional Materials, EarlyView.
In the work reported herein, dipole‐engineered sulfonated carbon nanofibers enable conductive additives to actively regulate interphase formation in silicon anodes. Polar sulfonyl groups guide electrolyte decomposition to form a compact LiF‐rich interphase while promoting robust integration with silicon.
Song Kyu Kang   +6 more
wiley   +1 more source

A method for in situ SEM fracture studies of brittle materials using the double torsion technique : application to nuclear graphite

open access: yes, 2011
This work concerned the design and development of a miniature double torsion (DT) testing rig, for use inside the chamber of a scanning electron microscope, to perform in situ loading studies of brittle materials using the DT fracture mechanics specimen.
Rosie, Kathryn A
core  

Resolving the Cu(bdc) Conundrum: Identifying Non‐Porous Packing of Prototypical Coordination‐Network Thin Films Combining Advanced Diffraction Techniques and Computational Modelling

open access: yesAdvanced Functional Materials, EarlyView.
Solution‐processed Cu(bdc) forms prototypical MOF thin films for which a multitude of not fully satisfactory structural models have been suggested. Combining rotating grazing‐incidence diffraction and X‐ray reflectivity on two complementary samples with density‐functional theory, we first discard the previously suggested models and then identify a non ...
Narges Taghizade   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy