Results 11 to 20 of about 914,958 (403)
Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6 [PDF]
Advanced Engineering Materials, EarlyView.The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter +4 more
openalex +2 more sources
Microstructural study of multiaxial low cycle fatigue [PDF]
Fracture and Structural Integrity, 2015 This paper discusses the relationship between the stress response and the microstructure under tension-torsion multiaxial proportional and nonproportional loadings.
Masao Sakane, Takamoto Itoh
doaj +3 more sources
Modification of creep and low cycle fatigue behaviour induced by welding [PDF]
Fracture and Structural Integrity, 2014 In this work, the mechanical properties of Waspaloy superalloy have been evaluated in case of welded repaired material and compared to base material. Test program considered flat specimens on base and TIG welded material subjected to static, low-cycle ...
A. Carofalo +6 more
doaj +2 more sources
Fatigue & Fracture of Engineering Materials & Structures, 2023 The key components in service, such as aero‐engine turbine blades, are generally bearing complex interactions of high and low cycle fatigue loading. It is essential to make accurate fatigue life predictions for these components.
Xiaowei Wang +5 more
semanticscholar +1 more source
Research on low cycle fatigue life prediction considering average strain
Materials Research Express, 2022 To address the difficult problems in the study of the effect of average strain on fatigue life under low-cycle fatigue loads, the effect of average strain on the low-cycle fatigue life of materials under different strain cycle ratios was discussed based ...
Yan Peng +3 more
doaj +1 more source
Low cycle fatigue properties of extruded magnesium AZ31B [PDF]
FME Transactions, 2022 The low cycle fatigue behavior of magnesium (Mg) AZ31B was observed at room temperature, in which its extrusion process led to differences in tensile and compressive stresses, with an increase in the grain structure and mechanical properties.
Sukmana Irza +3 more
doaj +1 more source
Crystals, 2022 Mechanical properties, including the fatigue behavior of metals, are usually determined from damage-free specimens, but it is not well known how these properties change with respect to prior damages; hence, the present work aims to understand the ...
Qing Liu +5 more
doaj +1 more source
Deformation Mechanisms of CoCrFeMnNi High-Entropy Alloy Under Low-Cycle-Fatigue Loading
Social Science Research Network, 2021 Plastic deformation during low-cycle fatigue (LCF) in equiatomic face-centered cubic (FCC) CoCrFeMnNi high-entropy alloys (HEAs) is accumulated by dislocation substructure formation, which leads to crack initiation.
K. Lu +6 more
semanticscholar +1 more source
Metals, 2023 This study investigated the tensile properties and fatigue behavior of FH36 steel plates subjected to alternating rolling processes in different directions, as well as their performance at room temperature and −60 °C.
Dong Wang +9 more
doaj +1 more source
Metals, 2023 The total strain amplitude controlled low-cycle fatigue tests were performed at room temperature and 200 °C to clarify the influence of 0.5% Ag addition on the low-cycle fatigue behavior of an Al-5Cu-0.8Mg-0.15Zr-0.2Sc (in wt.%) alloy subjected to the ...
Ying Wang +4 more
doaj +1 more source