Results 81 to 90 of about 64,518 (189)
Magnetorheological brake modeling with machine learning
, 2020 Precise control of the braking torque of an MR-brake (MRB) is possible with a control system using a Hall sensor which measures the magnetic field. Closed-loop controllers can be used to control the torque based on the Hall sensor readings. However, over time the fluid slowly leaks out of the MRB due to failure of rubber seals, which degrades the ...
openaire +2 more sources
Synthesis and Characterization of Antifriction Magnetorheological Fluids for Brake
Defence Science Journal, 2013 Magnetorheological (MR) fluids are smart materials with shear strength ranging between zero to 100 kPa under the influence of magnetic field. The present paper discusses the synthesis of MR fluid and its application in brake. In MR brake, gap between stator and rotor is filled with low (off-state) viscosity MR fluid.
Chiranjit Sarkar, Harish Hirani
openaire +1 more source
Durability Analysis of a Magneto-Rheological Fluid for Automotive Braking System
DesignsThe automotive market is looking for innovative braking solutions that can mitigate or eliminate secondary emissions. For this reason, new braking paradigms have been developed, and magnetorheological brakes could be considered a suitable solution due to
Giovanni Imberti +4 more
doaj +1 more source
THE EXPERIMENTAL DIDACTIC STAND FOR DETERMINING THE PARAMETERS OF THE GEAR WITH MAGNETORHEOLOGICAL CLUTCH AND BRAKE [PDF]
Scientific Journal of Silesian University of Technology. Series Transport, 2014 In this paper the laboratory stand, designed to be used as a part of the Laboratory of Machine Design and Research which is part of the subject Fundamentals of Machine Design, is presented.
Jerzy BAJKOWSKI
doaj
, 2018 In this article, thermal characteristics and tribological properties of a disk-type magnetorheological fluid–based brake are investigated under various brake operating conditions such as different working gaps.
Siyuan Wang +4 more
core +1 more source
An Investigation into the Influence of the Contact Pressure Distribution at the Friction Pair Interface on Disc Brake Squeal [PDF]
The main purpose of this thesis is to investigate the dynamic centre of pressure during a noisy brake application. A novel technique is employed to measure the centre of pressure and contact pressure distribution between the disc/pad interfaces during ...
Ashraf, Naveed
core +3 more sources
FluidsThis work focused on the development of a complete laboratory procedure for the rheological characterization of magnetorheological fluids (MRFs) by combining information gained from the literature and practical work performed in the laboratory.
Guglielmo Peruzzi +5 more
doaj +1 more source
International Journal of Engineering Research and, 2016 null Raj Kumar, null Jasbir Singh Ratol
openaire +1 more source
Design and experimental evaluation of a multi-drum magnetorheological brake with side-set dual-coil
Alexandria Engineering JournalTorque density, torque range and response time are the problems to be solved urgently in the field of magnetorheological (MR) transmission. To improve the torque, the most frequently used techniques are increasing the effective area and magnetic field ...
Jie Wu +3 more
doaj +1 more source
Squeeze Behaviors of Magnetorheological Fluids under Different Compressive Speeds. [PDF]
Materials (Basel), 2023 Wang H, Bi C, Liu W, Zhou F.
europepmc +1 more source