Influence of Manufacturing Defects on Mechanical Behavior of the Laser Powder Bed Fused Invar 36 Alloy: In-Situ X-ray Computed Tomography Studies. [PDF]
Materials (Basel), 2023 Yang S, Yang Q, Qu Z, Wei K.
europepmc +1 more source
Incorporating manufacturing defects in damage and failure analysis
, 2016 Traditional damage and failure analysis of composite materials has been on homogenized solids without defects. In recent years, it has been possible to observe and characterize defects induced by manufacturing.
Talreja, Ramesh,, R. Talreja
core +1 more source
Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland +5 more
wiley +1 more source
Surface defect identification by arc additive manufacturing and optimization compensation strategies
Hanjie xuebaoArc additive manufacturing has attracted extensive attention due to its advantages of high deposition rate, short cycle, and low cost, but it is prone to defects such as cracks, porosity, and non-fusion in the manufacturing process.
Hao DU +3 more
doaj +1 more source
Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics
Advanced Engineering Materials, EarlyView.Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost +4 more
wiley +1 more source
Delamination and Manufacturing Defects in Natural Fiber-Reinforced Hybrid Composite: A Review. [PDF]
Polymers (Basel), 2021 Suriani MJ +4 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff +9 more
wiley +1 more source
Application of mathematical morphology operation with memristor-based computation-in-memory architecture for detecting manufacturing defects. [PDF]
Fundam Res, 2022 Zhou Y +11 more
europepmc +1 more source
, 2019 Good Manufacturing Practices (GMPs) and Standard Operating Procedures (SOPs) forms the backbone of any professionally managed pharmaceutical industry.
Khan, S +6 more
core +1 more source