Results 71 to 80 of about 177,916 (201)

Toward Omni Healthcare: Wearable Technologies for Noncommunicable Disease Dynamic Monitoring

Medicine Bulletin, Volume 2, Issue 1, Page 5-19, January 2026.
ABSTRACT Noncommunicable diseases (NCDs)—including cardiovascular disorders, cancers, chronic respiratory diseases, and diabetes—account for over 41 million annual deaths globally. Emerging wearable biosensor platforms, leveraging synergistic breakthroughs in nanostructured conductive polymers and laser‐scribed graphene architectures, enable continuous
Xiaoxing Wang, Hui Xiao, Yinghui Zhao, Pingyun Li, Xiaolin Hu, Xiaopei Qiu, Chenglei Luo, Jie Luo, Kang Wang, Wei Gu, Huanyu Cheng, Hong Zhang, Yang Luo   +12 more
wiley   +1 more source

System Identification of a MEMS Gyroscope [PDF]

Journal of Dynamic Systems, Measurement, and Control, 1999
This paper reports the experimental system identification of the Jet Propulsion Laboratory MEMS vibratory rate gyroscope. A primary objective is to estimate the orientation of the stiffness matrix principal axes for important sensor dynamic modes with respect to the electrode pick-offs in the sensor.
M’Closkey, Robert T, Gibson, Steve, Hui, Jason   +2 more
openaire   +3 more sources

A MEMS IMU De-Noising Method Using Long Short Term Memory Recurrent Neural Networks (LSTM-RNN)

Sensors, 2018
Microelectromechanical Systems (MEMS) Inertial Measurement Unit (IMU) containing a three-orthogonal gyroscope and three-orthogonal accelerometer has been widely utilized in position and navigation, due to gradually improved accuracy and its small size ...
Changhui Jiang, Shuai Chen, Yuwei Chen, Boya Zhang, Ziyi Feng, Hui Zhou, Yuming Bo   +6 more
doaj   +1 more source

Event-Triggered Output Feedback Control for MEMS Gyroscope With Prescribed Performance

IEEE Access, 2020
This paper investigates an event-triggered output feedback control problem with guaranteed tracking performance for microelectromechanical system (MEMS) gyroscope subject to the lumped disturbances, including parameter uncertainties, coupling between ...
Yi Shi, Xingling Shao, Wei Yang, Wendong Zhang   +3 more
doaj   +1 more source

Dual‐Frequency Piezoelectric Vibration Energy Harvester for IoT‐Based Real‐Time Freight Train Health Monitoring in Mongolia

IET Intelligent Transport Systems, Volume 20, Issue 1, January/December 2026.
This study evaluates the potential of piezoelectric vibration energy harvesting to power IoT nodes for real‐time health monitoring of the Mongolian railway. Triaxial vibration data were collected at 500 Hz over a 400 km freight route under loaded and unloaded conditions using a custom ESP32‐S3 + MPU9250 system, and dominant frequencies were extracted ...
Bumduuren Pumbuurei, Batdalai Sukh, Nyamsuren Purevsuren, Buyankhishig Zundui, Myeirambyek Tashkyen, Heemin Park   +5 more
wiley   +1 more source

A Review on Dielectric Materials and Composites: Polarisation Effects, Synthesis Methods and Applications

IET Nanodielectrics, Volume 9, Issue 1, January/December 2026.
(1) The review consolidates the importance of dielectric polarisation effects, dielectric parameters, synthesis methods, matrix–filler interactions and emerging applications based on dielectric composite materials. (2) The study provides a structured overview by identifying critical aspects of dielectric research, with emphasis on polarisation ...
Kiran Keshyagol, Shivashankarayya Hiremath, Vishwanatha HM, Pavan Hiremath   +3 more
wiley   +1 more source

Predicting and Clustering Attitude‐Induced Divergence in Cross‐Array AOA Measurements for LEO Satellites

IET Radar, Sonar &Navigation, Volume 20, Issue 1, January/December 2026.
Example of cluster identification of attitude configurations to avoid in the attitude space (in terms of angles of roll, pitch and yaw) for a payload composed by a cross antenna array with angle of arrival technology for CubeSats platforms. ABSTRACT Satellite geolocation of radio‐frequency emitters increasingly relies on compact angle‐of‐arrival (AOA ...
Marcello Asciolla, Angela Cratere, Francesco Dell’Olio   +2 more
wiley   +1 more source

Accuracy Estimation of the Numerical Solutions for Chaotic Regime of the Pendulum With External and Parametric Excitation

Journal of Applied Mathematics, Volume 2026, Issue 1, 2026.
This study involves the development of a framework for checking the accuracy of built‐in algorithms from Mathcad software. The built‐in algorithms used inside Mathcad software include Runge–Kutta method of the fourth order (RK4), Adams method, backward differential formula, AdamsBDF, Radau, Bulstoer, Stiffr, and Stiffb methods.
M. C. Kekana, M. Y. Shatalov, S. E. Fadugba, N. Jeeva, T. O. Tong, Theodore Simos   +5 more
wiley   +1 more source

Study of the Influence of Phase Noise on the MEMS Disk Resonator Gyroscope Interface Circuit

Sensors, 2020
In this paper, a detailed analysis of the influence of phase noise on the micro-electro-mechanical system (MEMS) disk resonator gyroscope (DRG) is presented.
Wenbo Zhang, Weiping Chen, Liang Yin, Xinpeng Di, Dongliang Chen, Qiang Fu, Yufeng Zhang, Xiaowei Liu   +7 more
doaj   +1 more source

Object Recognition Using Deep Learning‐Powered Glove With Flex and MPU Sensors Fusion

Journal of Robotics, Volume 2026, Issue 1, 2026.
The integration of multimodal sensor data is critical for developing intelligent systems capable of extracting complex, insightful information. We introduce a robust platform for high‐fidelity and real‐time hand posture replication, as well as object classification, centered on a novel tactile‐sensing glove.
Joao Andre Ndombasi Diakusala, Zhigeng Pan, Ginias Lulendo Kiveni, Nenglun Chen, Habachi Bilal, Marcellin Atemkeng, Thierry Bouwmans, M. D. Sabbir Rahman, Ange Ntokusi, Sébastien Lalléchère, Blaise Ravelo, Yangmin Li   +11 more
wiley   +1 more source