Results 61 to 70 of about 3,718 (215)
Metallothermic Reduction of MoO3 on Combustion Synthesis of Molybdenum Silicides/MgAl2O4 Composites
, 2021 Combustion synthesis involving metallothermic reduction of MoO3 by dual reductants, Mg and Al, to enhance the reaction exothermicity was applied for the in situ production of Mo3Si–, Mo5Si3− and MoSi2–MgAl2O4 composites with a broad compositional range ...
Chun-Liang Yeh, Min-Chia Chen
core +1 more source
Interatomic potential of the MgAl2O4/Al interface and its application in strengthening mechanisms
Journal of Materials Research and TechnologyMgAl2O4 ceramics possess outstanding mechanical properties, making them promising for use as reinforcing or interfacial modulating phase in Al-based metal composites.
Aiqiong Pan +6 more
doaj +1 more source
High Temperature Materials and Processes, 2017 The directionally solidified eutectic MgAl2O4-Y3Al5O12 crystal was prepared at a pressure of 0.4 MPa of ambient nitrogen gas by the high frequency induction heated floating zone furnace.
Abalı Serkan
doaj +1 more source
Geostandards and Geoanalytical Research, Volume 50, Issue 2, Page 391-406, June 2026.Key Points A new magnetite reference material (PF21mt) is available for δ18O measurements by SIMS. Reproducibility of measurement results in two laboratories suggest orientation bias of ±2‰ (2s) at 20 keV. Repeatability improves to ±1‰ (2s) when using a 13 keV protocol, suggesting reduced orientation bias. In situ isotope ratio measurements provide the
Michelle Ulrich +4 more
wiley +1 more source
Compositional modifications in humidity sensing MgAl2O4 ceramics
, 2004 The MgAl2O4 powders were synthesized using the mixed oxide technique. The powders were doped with Na+ ion to modify the sintering behavior and the response characteristics of the spinel ceramics.
Timucin, M, Cambaz, G
core +1 more source
Advanced Engineering Materials, Volume 28, Issue 10, 20 May 2026.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
The Influencing Factor of MgAl2O4 on Heterogeneous Nucleation and Grain Refinement in Al Alloy Melts
, 2020 Grain refinement using oxide additions is commercially feasible and ecofriendly. MgAl2O4 has a lattice structure similar to Al and small lattice misfits with Al, and it can be an effective nucleation core when it meets certain conditions.
Lu Wang, Lin Yang, Mei Yang
core +1 more source
Advanced Engineering Materials, Volume 28, Issue 10, 20 May 2026.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Effect of Annealing Temperature on Thermal Behaviour and Crystallinity of Zinc Oxide Supported Magnesium Aluminate (ZnO/MgAl2O4) Via Green Synthesis One Pot Fusion [PDF]
Archives of Metallurgy and MaterialsZinc oxide-supported magnesium aluminate (ZnO/MgAl2O4) was synthesized by the one-pot fusion method, consuming magnesium nitrate, aluminum nitrate, and citric acid as starting precursors.
N.S. Sukiman +3 more
doaj +1 more source
Physical review. B, Condensed matter, 1991 V centers induced by ionizing irradiation at 80 or 300 K in single-crystal and polycrystalline MgAl2O4 samples have been studied by use of electron paramagnetic resonance and optical absorption. Vt- and Vo2- centers, as a result of hole trapping at tetrahedral and octahedral cation vacancies, respectively, have been found to be responsible for two EPR ...
Ibarra, A. +2 more
openaire +2 more sources