Results 71 to 80 of about 155,041 (322)
Sensors, 2015 Most experimental fields of science and engineering require the use of data acquisition systems (DAQ), devices in charge of sampling and converting electrical signals into digital data and, typically, performing all of the required signal preconditioning.
José Luis Blanco-Claraco +3 more
doaj +1 more source
Advanced Materials, EarlyView.TGTMW fibers are designed to show a sharp resistance increase under pressure, as the multi‐wall structure in the transition region between compressed and uncompressed areas bends and forms microcracks. This design breaks the physical sensitivity limit of conventional fiber‐shaped pressure sensors, which usually show resistance reduction under pressure ...
Ziwei Chen +7 more
wiley +1 more source
Tecnura, 2014 This paper presents the design and implementation of a data acquisition system to identify the different vector groups of the triphase transformer DL1080. This design is based on computational tools in hardware and software such as Microchips and Labview
César Augusto Hernández Suarez +2 more
doaj +1 more source
IMPLEMENTATION PID IN THE SYSTEM CONTROL SPACE HEATER BASED MICROCONTROLLER ATMega 8535 [PDF]
Final project aims to make hardware and software space heaters as a PID control system automatically controls heating control room and to know the performance of PID control applications using microcontroller ATmega 8535.
Haryanto S., R. Novianto Dwi
core
3D Printing of Highly Electrically Conductive Zinc for Sustainable Electronics Applications
Advanced Materials Technologies, Volume 10, Issue 6, March 18, 2025.A 3D printable zinc ink system with active zinc particles in a shellac matrix is demonstrated. The results show high conductivity, stable performance of printed structures under varying humidity conditions, and promising application in disposable water‐activated batteries. This technology combining digital material assembly, reliable operation, and non‐
Xavier Aeby +5 more
wiley +1 more source
Electronic system for drift clock calculation and synchronization for seafloor observatory [PDF]
, 2016 The paper describes a new electronic device that allows an easily measurement of the drift between a reference time source (usually GPS) and an atomic rubidium clock which is normally used in seafloor observatories.
Apponi, Umberto +3 more
core
Printed Interconnects for Heterogeneous Systems Integration on Flexible Substrates
Advanced Materials Technologies, Volume 10, Issue 6, March 18, 2025.Key components (sensors, energy devices, communication devices, computing chips, and interconnects) of flexible hybrid electronic (FHE) system connected via conductive printed metal tracks. The figure in the insets shows out‐of‐plane printed interconnects providing opportunities for lithography‐free formation of VIAs, in‐plane access of UTCs pads, and ...
Abhishek Singh Dahiya +3 more
wiley +1 more source
Control System Hardware Design, Analysis and Characterization of Electromagnetic Diaphragm Pump
Applied SciencesIn this article, a novel electromagnetic diaphragm pump design controlled by an Arduino NANO microcontroller is proposed to pump liquid inside the pumping chamber completely separated from mechanical and transmission parts.
Szymon Skupień +3 more
doaj +1 more source
EAI Endorsed Transactions on e-Learning, 2017 This paper describes the introduction of the use of physical artefacts in the teaching of the curriculum in the Department of Computer Science at Middlesex University.
E. Currie, C. James-Reynolds
doaj +1 more source
Advanced Materials Technologies, Volume 10, Issue 6, March 18, 2025.The given research presents an innovative insole‐based device employing self‐powered triboelectric nanogenerators (TENG) for flatfoot detection. By integrating TENG tactile sensors within an insole, the device converts mechanical energy from foot movements to electrical signals analyzed via machine learning, achieving an 82% accuracy rate in flatfoot ...
Moldir Issabek +7 more
wiley +1 more source