Results 21 to 30 of about 13,014 (262)
The miscibility between hydrophobic and hydrophilic biopolymers has been of significant challenge. This study used a novel simplified chitin modification method to produce phthalic chitin using phthalic anhydride in a substitution reaction.
N. G. Olaiya +8 more
doaj +1 more source
Solvate ionic liquids lubrication reduced the coefficient of friction by ∼60% compared to dry sliding, reaching steady‐state values as low as 0.04–0.05. Corrosion weight‐loss measurements in 1 M HCl further demonstrated significant inhibition behavior, with only 100 ppm of [Li(G3)][TFSI] (∼68.5 μL/L) reducing corrosion‐product weight loss by 63 ...
Sameh Dabees +6 more
wiley +1 more source
Counterion Dependent Side‐Chain Relaxation Stiffens a Chemically Doped Thienothiophene Copolymer
Oxidation of a thienothiophene copolymer, p(g3TT‐T2), via different doping strategies and dopant molecules resulted in materials with similar oxidation levels and a high electrical conductivity of ≈100 S cm−1. However, mechanical properties varied significantly, with sub‐glass transition temperatures and elastic moduli spanning from –44°C to –3°C and ...
Mariavittoria Craighero +12 more
wiley +1 more source
Receptor‐Free Identification of Toxic Gases Enabled by Hygroscopic Aqueous Salt Films
Water as a gas sensor coating sounds impossible—until it stops evaporating. Here, hygroscopic salt solutions (LiCl, LiBr, H3PO4) form non‐drying aqueous films on CNT chemiresistors under ambient air. Gases partition into these liquid layers, sometimes transforming into water, and generate salt‐specific resistance fingerprints across a four‐channel ...
Seongwoo Lee +5 more
wiley +1 more source
This paper addresses the compatibility, morphological characteristics, crystallization, physico-mechanical properties and thermal stability of the melt mixed EMA/NBR blends. FTIR spectroscopy reveals considerable physical interaction between the polymers
Murugan N. +2 more
doaj +1 more source
Electrospun Wood‐Derived Biopolymers as Electrodes in Electrochemical Energy Storage Technologies
Electrospinning transforms wood‐derived cellulose and lignin into architecturally defined, binder‐free carbon electrodes with tuneable porosity and functionality. This review shows how fibre design enables decoupled charge and mass transport, enhancing performance across battery systems, while identifying key challenges in spinnability, scalability ...
Michael W. Thielke +3 more
wiley +1 more source
ObjectiveAgainst the backdrop of the “dual carbon” goals, methanol holds significant potential as a clean liquid fuel and hydrogen carrierfor large-scale pipeline transport.
Shujuan QIU +7 more
doaj +1 more source
A novel oil–water selective conformance control agent, MPRP, is prepared via hydrophilic grafting and mechanical granulation. MPRP uniformly disperses in water, cohesively expands upon aging, and readily dissolves in the oil phase. During conformance control, it selectively aggregates in water channeling pathways to form effective plugs without ...
Guang Zhao +6 more
wiley +1 more source
Chitosan is a polysaccharide vastly examined in polymer science for its unique structure. In the present study, CS was derivatized with 2-methoxy-4vinylphenol (MVP) in four different ratios through a free radical reaction.
Georgia Michailidou +2 more
doaj +1 more source
Tuning Redox Dynamics in Cu‐Based Electrocatalysts: Effect of Secondary Metals
Advanced analysis of operando X‐ray absorption spectroscopy data reveals that secondary metals affect the redox processes in Cu‐based catalysts for electrocatalytic CO2 reduction. This influences the amount of oxides formed under pulsed reaction conditions and the distribution of reaction products.
Martina Rüscher +17 more
wiley +1 more source

