Results 81 to 90 of about 48,493 (172)

Effects of Progressive Inspiratory Muscle Training on Lung Volume and Respiratory Strength in Patients With Pre‐Dialysis Chronic Kidney Disease

open access: yesPhysiotherapy Research International, Volume 31, Issue 4, October 2026.
ABSTRACT Introduction Chronic kidney disease can present changes in thoracic cavity volume and respiratory muscle weakness, even in the pre‐dialysis stage. However, there is little evidence on the effects of inspiratory muscle training in these patients.
Mônica Soares de Oliveira   +6 more
wiley   +1 more source

NDT for CFRP aeronautical components a comparative study

open access: yes, 2011
9 S.Carbon fibre reinforced polymers (CFRP) have become a material of emerging interest for aeronautical structures. This requires this material to be qualified by means of NDT.
Bulavinov, A.   +7 more
core   +1 more source

Unmanned Aerial Systems for Corrosion Detection: Multi‐Sensor Technologies, Challenges, and Opportunities for Next‐Generation Inspection

open access: yesQuality and Reliability Engineering International, Volume 42, Issue 6, Page 3565-3583, October 2026.
ABSTRACT Corrosion remains a critical threat to the integrity and service life of infrastructure in industries such as oil, gas, construction, renewable energy, and transportation. Traditional inspection methods, being labor‐intensive, hazardous, and often subjective, fall short in addressing modern inspection demands.
Alhossein Alharbi   +3 more
wiley   +1 more source

In Situ Formation of L12‐Al3Ti Precipitates Enabling High Strength and Toughness in Oscillating Laser‐Welded Aluminum Alloy

open access: yesRare Metals, Volume 45, Issue 10, October 2026.
ABSTRACT A synergistic strategy combining a Ti interlayer and circular beam oscillation was proposed to improve the laser weldability of 6082‐T6 aluminum alloy. The Ti interlayer suppressed porosity, eliminated columnar grains, and significantly reduced grain size by 67.7% at the weld center. Mechanistically, fine L12‐Al3Ti precipitates clearly showing
Zhongping Hou   +8 more
wiley   +1 more source

Interpreting results of NDT/SHM methods based on elastic guided waves in composite plate-like structures by a semi-analytic modal simulation tool

open access: yes, 2019
International audienceElastic guided waves (GW) are valuably used for NDT/SHM of metallic or composite plate-like structures. They allow fast scanning of large parts for the detection of all kinds of inner or surface defects and flaws.
Barras, Jordan, Lhémery, Alain
core   +1 more source

De Novo Discovery of Bioactive Cyclic Peptides via Cellular Selection of Genetically Encoded Libraries

open access: yesChemBioChem, Volume 27, Issue 18, 28 September 2026.
Genetically encoded cyclic peptide libraries can be employed in cellular selection platforms to identify cyclic peptide inhibitors for therapeutic targets by directly selecting for desired biological activities. This review systematically summarizes representative studies and suggests future opportunities for using cellular selection for de novo cyclic
Linwei Yang   +3 more
wiley   +1 more source

Inverse Problems of Eddy Current Testing and Uncertainties Evaluation

open access: yesAdvances in Electrical and Electronic Engineering, 2006
This paper deals with the problem of uncertainties evaluation when the procedure of inverse problems is used for processing the eddy current testing data. First the general inverse problem algorithm is described.
Karol Grondzak
doaj  

Microwave Nondestructive Testing of Dielectric Materials

open access: yesAdvances in Electrical and Electronic Engineering, 2006
The article focuses on measurements on pertinax and polyethylene samples to obtain their material characteristics by means of microwave investigation. Evaluation of the results is performed and accuracy possibilities are discussed.
Dagmar Faktorova
doaj  

Fem Analysis of Residual Stresses in Welded Aluminum and Polyamide 6

open access: yesFatigue of Aircraft Structures
Thermoplastic composites enable weldable, recyclable aircraft structures, but thermal mismatch between metals and polymers can introduce detrimental residual stresses. This study develops a finite element method (FEM) framework to predict residual stress
Praski Marcin   +4 more
doaj   +1 more source

MATERIAL DAMAGE ASSESSMENT AND STRUCTURAL HEALTH MONITORING OF HISTORICAL HERITAGES BY USING NDT TECHNIQUES AND PROXIMAL REMOTE SENSING TOOLS

open access: yes, 2015
The risk and the vulnerability mitigation of historical heritages (e.g. churches, museums and monuments) is an actual relevant topic of interest for their safeguarding with respect to environmental risks, for example considering the high seismic hazard ...
Montuori, A.   +4 more
core   +1 more source

Home - About - Disclaimer - Privacy