Results 221 to 230 of about 6,622,719 (397)

Excellent Catalytic Performances of a Au/C–CuO Binary System in the Selective Oxidation of Benzylamines to Imines under Atmospheric Oxygen

open access: gold, 2021
Yuki Yamamoto   +7 more
openalex   +1 more source

Challenges during Flash Lamp Annealing of Aerosol‐Deposited Barium Titanate Films

open access: yesAdvanced Engineering Materials, EarlyView.
Aerosol deposition is used to rapidly deposit barium titanate films with thicknesses ranging from 2 to 16 μm at room temperature, eliminating the need for further densification. However, to recover the electromechanical properties, annealing is required, which limits the usage of temperature‐sensitive substrates.
Michel Kuhfuß   +7 more
wiley   +1 more source

Interactions between Molten High‐Silicon Electrical Steels and Carbon‐Bonded MgO Refractories Based on Recyclates

open access: yesAdvanced Engineering Materials, EarlyView.
This study examines how several molten high‐silicon electrical steels interact with both conventional and recycled MgO–C refractories. For this, various immersion experiments are conducted. In addition to infiltration, a number of mechanisms are identified and explained that control the corrosion of the refractory material.
Lukas Neubert   +7 more
wiley   +1 more source

Low hyper-oxygen exposure induces p21-dependent p53-independent senescence in alveolar cells. [PDF]

open access: yesInt J Med Sci
Lee CH   +7 more
europepmc   +1 more source

Enhanced Oxidation and Thermal Shock Resistance of N‐type Mg2Si0.89(Sn0.1,Sb0.01) Thermoelectric Material via Cr0.9Si0.1 Coating

open access: yesAdvanced Engineering Materials, EarlyView.
Cr0.9Si0.1 protective coatings are developed to enhance the thermal‐shock and oxidation resistance of Mg2Si0.89(Sn0.1,Sb0.01) thermoelectric (TE) materials. The coating forms a dense and adherent barrier that suppresses oxygen diffusion and mitigates mechanical degradation during cyclic oxidation, demonstrating its potential to improve the long‐term ...
Mikdat Gurtaran   +3 more
wiley   +1 more source

Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6

open access: yesAdvanced Engineering Materials, EarlyView.
The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy