Results 61 to 70 of about 1,889,452 (289)
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Electrostatic measurement system [PDF]
, 1975 A system for and method of contact-electrifying a dielectric to determine its electrostatic properties is described. The dielectric is placed in contact with a contact plate means, and connected to a voltage source means to charge the contact plate and ...
Johnston, J. E.
core +1 more source
Non-Contact Friction for Ion-Surface Interactions
, 2015 Non-contact friction forces are exerted on physical systems through dissipative processes, when the two systems are not in physical contact with each other, or, in quantum mechanical terms, when the overlap of their wave functions is negligible.
Jentschura, U. D., Lach, G.
core +1 more source
Hydrodynamics of the Binary Contact Path Process
, 2019 In this paper we are concerned with the binary contact path process introduced in \cite{Gri1983} on the lattice $\mathbb{Z}^d$ with $d\geq 3$. Our main result gives a hydrodynamic limit of the process, which is the solution to a heat equation. The proof of our result follows the strategy introduced in \cite{kipnis+landim99} to give hydrodynamic limit ...
Xue, Xiaofeng, Zhao, Linjie
openaire +2 more sources
Path-following energy optimization in unilateral contact problems
Journal of Global Optimization, 1995 zbMATH Open Web Interface contents unavailable due to conflicting licenses.
Σταυρουλακης Γεωργιος(http://users.isc.tuc.gr/~gestavroulakis) +2 more
openaire +3 more sources
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Jixie chuandong, 2012 The meshing and contact mathematic model of crossed helical gears is established.The 3d contact model of crossed helical gears is built,and 3d contact path is simulated by MATLAB software simulation technology.The two-dimensional crossed helical gears ...
师军伟 +4 more
doaj
Contact Potential Instability in the Path-Integral Description of Itinerant Ferromagnetism [PDF]
Journal of Low Temperature Physics, 2015 11 pages, 1 ...
Vermeyen, Enya, Tempere, Jacques
openaire +3 more sources
Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma
Advanced Engineering Materials, EarlyView.The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie +4 more
wiley +1 more source